Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY RULES FOR BELT POWER SUPPLY
WARNING!
READ AND UNDERSTAND ALL INSTRUCTIONS. Fail-
ure to follow all instructions listed below, may result in
electric shock, fire and/or serious personal injury.
„ Before using the 40V belt power supply, read all in-
structions and cautionary markings in this manual, on the
belt power supply, adaptor and product using adaptor
to prevent misuse of the products and possible injury
or damage.
„ Use of an attachment not recommended or sold by
the product's manufacturer may result in a risk of
fire, electric shock, or injury to persons. Following this
rule will reduce the risk of electric shock, fire, or serious
personal injury.
„ Keep RYOBI 40V belt power supply away from heat to
prevent damage to housing or internal parts.
„ Do not let gasoline, oils, petroleum-based products,
etc. come in contact with plastic parts. They contain
chemicals that can damage, weaken, or destroy plastic.
„ Always wear eye protection with side shields marked
to comply with ANSI Z87.1. Failure to do so could result
in objects being thrown into your eyes resulting in pos-
sible serious injury.
„ Do not use the RYOBI 40V belt power supply if it has
been damaged, doing so could cause shorting and elec-
tric shock. If damaged, have the 40V belt power supply
replaced by an authorized serviceman.
„ Do not operate the RYOBI 40V belt power supply if
it has received a sharp blow, been dropped, or oth-
erwise damaged in any way. Take it to an authorized
serviceman for electrical check to determine if it is in
good working order.
„ Do not operate belt power supply with a damaged
cord or plug, which could cause shorting and electric
shock. If damaged, have the belt power supply replaced
by an authorized serviceman.
„ Do not disassemble RYOBI 40V belt power supply.
Take it to an authorized serviceman when service or repair
is required. Incorrect reassembly may result in a risk of
electric shock or fire.
„ Disconnect RYOBI 40V belt power supply and remove
battery packs before attempting any maintenance or
cleaning to reduce the risk of electric shock.
„ Disconnect RYOBI 40V belt power supply and remove
battery packs when not in use.
„ Risk of electric shock. Do not touch uninsulated por-
tion of output connector or uninsulated battery terminal.
„ Do not charge battery in a damp or wet location. Do
not use, store, or charge battery packs or products
in locations where the temperature is less than 50°F
or more than 100°F. Do not store outside or in vehicles.
„ Save these instructions. Refer to them frequently and
use them to instruct others who may use this tool. If you
loan someone this tool, loan them these instructions also
to prevent misuse of the product and possible injury.
2 — English
Publicidad
