Philips SBC RU 240 Instrucciones De Manejo página 4

Instructions for use
All manuals and user guides at all-guides.com
5
Enter your 3-digit code using the number keys, within
-
30 seconds.
– The green LED flashes twice.
C h e c k
That's it! Press a few keys to check correct response. If
response is not correct, repeat procedure beginning at step 1.
N o t e
- If the LED displays one long flash, the code was not
recognised. Please go back to step 1 and repeat the
procedure, using the next 3-digit code in the list.
- If no key is pressed within 30 seconds, you have to start
again at step 1.
A d v i c e
Carefully read the complete procedure before starting!
You do not know the brand of your
equipment/you can not find the right code in
the code list » auto search:
1
Press the mode selector key for the device (TV, VCR, SAT
or AUX) you want to operate.
2
Make sure the device is switched on (if the device is a
VCR, please insert a tape and start playback).
3
Press and hold keys 1 and 3 simultaneously -for about
three seconds- until the green LED lights up.
(Release the keys: the green LED should stay on)
4
Press the power key to start the search. Make sure that
you keep the remote control pointed at your equipment.
– Each time the green LED flashes, another code is sent.
When the right code is found, the equipment switches off.
Immediately press the power key to stop the search.
If the green LED flashed again after the equipment
switched off, this means you missed the correct code! If
you missed the code, follow the next proccedure, starting
at step 5. If the LED did not flash again after the
equipment switched off, go to step 7.
5
Switch the equipment manually back on.
6
Press 'P' (down only!) repeatedly to send previous codes
until the equipment switches off again.
7
Press the power key to lock the correct code in the SBC
RU240's memory.
– The green LED flashes twice.
C h e c k
Switch equipment on manually. Press a few keys to check correct
response. If response is not correct, repeat procedure beginning
at step 1.
4