Roberts LONGNECK PLUS 6 Manual De Operación página 3

All manuals and user guides at all-guides.com
GENERAL SAFETY RULES CONTINUED
MAINTENANCE:
1. Clean out accumulated dust.
2. Check the brushes periodically for wear and replace both brushes when either is worn to
about 1/3 in length.
DO NOT MAKE ANY ADJUSTMENT WHILE THE MOTOR IS IN MOTION!
WARNING
KEEP SAFETY GUARDS IN PLACE TO AVOID POSSIBLE SERIOUS INJURY!
Never cover, nor allow dust to accumulate in air vents since they must always be open for
proper motor cooling.
Always remove the electric cord from the power supply before changing brushes, lubricating or
when working on the unit, to avoid possible serious injury.
To assure safety and reliability all repairs with the exception of external accessible brushes
should be performed by an Authorized Service Center or other qualified Service Organization.
PRODUCT SPECIFIC SAFETY WARNINGS
1. The Roberts 10-56 LONGNECK PLUS 6" Jamb Saw is manufactured for the specific use of
trimming wood door jambs, base molding, and undercutting brick. It can cause bodily harm
if used improperly or if operated by inexperienced persons.
2. Do not use this product for any purpose other than stated in these instructions.
3. Never operate this saw "freehand".
4. Always wear eye protection and gloves. It is recommended that safety goggles which are
fully enclosed and contact your forehead and cheeks be worn to prevent injury. Do not wear
loose clothing. Dust masks are recommended.
5. Unplug the Roberts 10-56 LONGNECK PLUS 6" Jamb Saw when not in use. Store it in the
custom molded case.
6. Keep blade safety guards installed at all times.
7. Avoid hitting nails, screws, masonry, tile or other hard materials. Keep work area clear of
tools and scraps.
a. These materials can cause dangerous chips and debris to be ejected from the saw.
b. The blade will be damaged or dulled. Teeth can be broken or bent, requiring
replacement of the blade.
c. Check jambs and base moldings carefully to locate nails or other fasteners so they can
be removed or avoided during trimming.
8. Do not use this or any electric tool on wet floors or near standing water.
9. Make sure blade screw and handle retaining nuts are tightened securely
before operating.
ADVISORY: Use the shortest extension cord possible to avoid loss of electric power.
We recommend 25 ft. 12 gauge extension cord.
WARNING:
Some dust created by power sanding, sawing, grinding, drilling and other
construction activities contains chemicals known to the State of California
to cause cancer, birth defects or other reproductive harm. Some examples of these chemicals are:
• lead from lead-based paints
• crystalline silica from brick, cement and other masonry product, and
• arsenic and chromium from chemically-treated lumber.
Your risk from these exposures varies, depending on how often you do this type of work.
To reduce your exposure to these chemicals: work in a well-ventilated area, and work with
approved safety equipment, such as those dust masks that are specially designed to filter
out microscopic particles.
After use, check tool to keep it in top condition.