Care And Maintenance - Orbegozo AP 8030 Manual De Instrucciones

AP 8030
Caution!
The filter material is soft and sensitive, so cleaning the filter must be gentle. Only ever clean the filter with
clean water and do not use soap or detergent, they would destroy the filter.
Cleaning the exhaust air filter
The exhaust air filter cleans the air at the end before it leaves the
vacuum cleaner. You can clean this exhaust filter following below
instructions:
1. Turn off and unplug the vacuum cleaner. Remember pull on the
plug and not on the cord.
2. Turn exhaust air grill to anti-clockwise and remove it.
3. Then, turn the filter to anti-clockwise and you can already remove
it.
4. You can take out the filter from its holder and to clean it rinse the filter with cold water for a while and
after that let it dry.
Caution!
1. Always clean the filter with clear water and don't use soap or detergent. It would damage the filter.
2. Clean filter with clear water and dry it naturally. Do not dry with heat, it could deform.

CARE AND MAINTENANCE

Cleaning of vacuum cleaner
To clean the housing of device, disconnect and unplug it.
Danger! Never expose the vacuum cleaner to the effects of weather (rain, wind, etc.). No parts may be
washed by dish washer.
The housing, inner tank and rear outlet can be wiped with a damp cloth, always taking care that no liquids
get inside vacuum cleaner. Do not use strong products to clean the device because it could corrode the
plastic surface. Before to plug again vacuum cleaner ensure that all parts are thoroughly dry.
Hair and fluff may gather on the running wheels and on the floor nozzle of the vacuum cleaner in time. You
should remove there to ensure that handling of the vacuum cleaner is always easy.
Note: we do not recommend using lubricant or oil on wheels because it will cause dirt and fluff to
stick even better.
15