Troubleshooting; Error Codes - McCulloch Li 58GBP Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 78
Problem
Possible cause
The product
The power is off.
does not start
No electrical contact between
the product and battery pack.
The battery pack is not charged. Charge the battery pack. See the operator's manual for the bat-
The battery pack or product are
too hot.
The battery pack or product are
too cold.
Motor controller is too hot.

Error codes

The error codes help you do troubleshooting on the
battery pack and/or the battery charger while it charges.
(Fig. 36 )
LED screen
LED 1 is red and LED 4 is
green, battery pack does not
charge or operate correctly in
product
LED 1 is red
LED 4 is green
LED 1 is red and LED 2 is
green, battery pack does not
charge or operate correctly in
product
RED LED comes on, LED 2
is green and flashes during
charging or when the battery
pack is in the battery charger
12

TROUBLESHOOTING

Possible solution
Start the power. See
Install the battery pack correctly. See
on page 10 .
tery pack.
Let the battery pack and product cool down before you start the
product.
Let the battery pack and product become warm before you start
the product.
Let the battery pack and product cool down for a minimum of 1
hour before you start the product.
Possible faults
Internal fuse is blown
Irregular cell voltage
Battery pack is over-
charged
Battery pack failure
Internal battery tempa-
ture is too low or too
high for charging
To start the motor on page 10 .
Note: Look at the battery state of charge LED with the
ribs of the battery pointed up to see the correct
orientation of the LED lights.
Possible steps
Speak to an approved service center.
Speak to an approved service center.
Remove the battery pack from the battery charger and in-
stall in the product. Operate the product. Battery charger
may be defective. Speak to an approved service center.
Remove battery pack from the product. Do not charge.
Battery pack is damaged and must be replaced. Speak to
an approved service center.
Move the battery charger and battery pack to a location
where the internal temperature of the battery pack can be
between 5°C (41°F) and 45°C (113°F).
To install the battery pack
449 - 003 - 20.11.2017

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido