Publicidad
Idiomas disponibles
Idiomas disponibles
4. Remote controller
5. Transport handle
6. Exhaust duct
7. Evaporator inlet
8. Cooler drain port
9. Air exhaust duct
10. Connector of air exhaust duct
11. Window exhaust adapter
CONTROL PANEL (picture C)
A. Power button ON/OFF
C. Mode button
E. Timer / Temperature down button
G. High speed lamp
J. Automatic mode
L. Dehumidifying mode
N. Timer button
REMOTE CONTROLLER – picture D
The remote controller transmits signals to the system.
Button "A" - the appliance will be started when it is energized or will be stopped when it is in operation, if you press this button.
Button "C" - press it to select operation mode: "J", "K", "L" or "M".
Button "B" - press it to select fan speed in sequence.
Button "D" / "E" - press to adjust the room temperature and the timer.
Button "I" - press to set or cancel sleep mode.
Button "N" - press to set the time of automatic off and automatic on.
OPERATION OF THE CONTROL PANEL
AUTOMATIC / COOLING / DEHUMIDIFYIING / FAN
1. Turn on the device.
a) Connect the device.
b) Press the "A" button, then the device beeps once and turn on.
c) LED diode displays room temperature and starts working in automatic mode.
2.Choose the operating mode
Press the "C" button to select the desired mode of operation by sequence:
Automatic mode "J" -> Cooling mode "K" -> Dehumidifying mode "L" -> Fan mode "M."
3. Adjust temperature
The temperature can be set within a range 15°-31°C. Press "D" or "E" button to increase or decrease the temperature by 1°C by pressing
once. The device LED panel shows the target temperature for 5 seconds and then displays the room temperature.
4. Adjust fan speed
Press the button "B" to select a desired fan speed shows by sequence:
Low speed "F" -> High speed G
5. Power
When you press the "A" button again, the device will sound "di" and stop working.
6. Press this button "I" to enter the sleep mode of device.
7. Press this button "N" to set a timed shutdown.
Each mode working principle:
AUTOMATIC "J" mode:
Once the "J", operation is selected, the indoor temperature sensor operates automatically and it selects one of below operation modes:
- When the room temperature ≥24 ℃ the unit will automatically select cool mode "K" mode.
or
B. Fan speed button
D. Timer / Temperature up button
F. Low speed lamp
I. Sleeping button
K. Cooling mode
M. Fan mode
6
Publicidad
