JeaTone V10W Guia De Inicio Rapido página 2

English
Packing list
After opeing the package, please make sure the doorbell is in good condition
verify parts below is complete.
Doorbell User Guide
Appearance Introduction
IR Leds
Lens
Button
The ambient light is not enough, to enable the infared
IR Leds
light, increase the environmental brightness.
Light Sensor
Used to collect environmental brightness value, when
the intensity of illumination is lesss than 2 Lux, enable
the IR LEDs.
MIC Audio capture.
Button
The doorbell button.
PIR
When human body movement in front of the doorbell,
the doorbell could be made the notification to your
mobile phone.
Lens
Video image capture.
Indicator Light
Blinking blue: configuration status.
Long red light: failed to connect WIFI.
Blue light is on: the device is connected successfully.
Red and blue light together: The device is connected to
WIFI.
Speaker
Make a sound of the doorbell, and voice intercom.
Security Screw Screw bag
PIR
Light Sensor
MIC
Indicator Light
Speaker
1
AC Input
Reset Button
Battery
Comartment
AC Input
Support AC power supply input for doorbell.
Reset Button
Doorbell working status, long press 5 seconds to restore factory
settings.
Battery
Mounting 18650 specification battery.
Comartment
Fixed hole Fit the support on the wall with the mounting screws for the mounting
kit. Mounting the doorbell onto the bracket.
Security
Mounting the security screw on the fittings to prevent the doorbell
Screw hole from being removed.
TF Card
TF card maximum support 64GB.
USB
Charge the battery
Installation
As shown in the figure.
1. Use the screws in the mounting kit to fit the bracket on the wall.
2. The conductive screws in the accessories pack are used to connect the
AC (16-24V) wire to the AC input hole (If no AC power adaptor is available,
this step can be omitted).
3. Press the reset button for 5 seconds, waitting for the indicator light to
slow down (The doorbell should be in working condition, long press, sleep
state is invalid).
4. Mounting three 18650 specification batteries.
5. Cover the battery cover, align the doorbell and the bracket, push down
and lock the security screws to complete the installation.
Fixed hole
TF Card
Fixed hole
Security screw hole
3
1
4
2
5
2
English
USB