D) TRACK SEPARATION (BY REMOTE HANDSET)
YOU CAN DIVIDE THE RECORDING MUSIC FROM PHONO TO USB TRACK BY TRACE DURING ENCODING.
EVERY TIME WHEN PRESS THE "
ENCODING FROM PHONO TO USB, THE SYSTEM WILL GENERATE A NEW TRACK AND CONTINUOUS THE
RECRODING. THE TEXT " PHONO " AT LCD DISPLAY WILL FLASHING ONE TIME, IT MEAN THE UNIT IS CREATING
A NEW TRACK SUCCESSFULLY.
FILE DELETE AT USB (BY REMOTE CONTROL)
THE SYSTEM IS ABLE TO ERASE THE FILE STORED INSIDE THE USB PEN DRIVE BY FOLLOWING:-
A) SINGLE FILE DELETE
1.
PRESET AT " USB " OR MODE.
2.
PRESS AND HOLD THE " INFO " BUTTON FOR 3 SECONDS AND THE LCD DISPLAY (18) WILL SHOW (DEL
---001)
3.
PRESS SKIP FORWARD
4.
PRESS THE " REC " BUTTON TO ENTER " YES / NO " MODE AND THEN PRESS SKIP FORWARD
BACKWARD
TO SELECT " YES " OR " NO ".
5.
PRESS THE " REC " BUTTON AGAIN TO CONFIRM THE SETTING.
B) ALL FILES DELETE
1. PRESET AT " USB " MODE.
2. PRESS AND HOLD THE " INFO " BUTTON FOR 3 SECONDS AND THE LCD DISPLAY (18) WILL SHOW (DEL
---001)
3. PRESS AND HOLD THE " INFO " BUTTON TO ENTER " YES / NO " MODE AND THEN PRESS SKIP FORWARD
OR SKIP BACKWARD
4. PRESS THE " REC " BUTTON AGAIN TO CONFIRM THE SETTING.
REMOVING OF USB
TO REMOVE THE USB, TURN OFF THE POWER OR SWITCH THE FUNCTION MODE TO EITHER CD OR TUNER
FIRST. FOR USB PORT – UN-PLUG IT BY PULLING OUT THE USB SOCKET DIRECTLY.
PHONO
NOTED:
-
REMOVE THE STYLUS PROTECTOR.
-
BE SURE THAT THE TONE ARM IS BEING DETACHED FROM THE TONE ARM REST
BEFORE OPERATING AND RE-SECURED AGAIN AFTERWARDS.
1.
SELECT TO " PHONO/BT " FUNCTION FROM FUNCTION SELECTOR (18)
2.
SET THE SPEED SELECTOR TO THE PROPER POSITION DEPENDING ON THE RECORD TO BE PLAYED.
3.
PLACE THE RECORD ON THE PLATTER (USE THE SPINDLE ADAPTOR IF REQUIRED).
4.
LIFT THE TONE ARM FROM THE REST AND SLOWLY MOVE IT TO THE RECORD SIDE.
THE PLATTER WILL START TO ROTATE.
5.
PLACE THE TONE ARM TO THE DESIRED POSITION OF THE RECORD.
6.
ADJUST THE VOLUME TO THE DESIRED LEVEL.
7.
AT THE END OF RECORD, THE PLATTER WILL AUTOMATICALLY STOP ROTATING. LIFT
THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST.
8.
TO STOP MANUALLY, LIFT THE TONE ARM FROM THE RECORD AND RETURN IT TO THE REST.
REMARK : AS SOME KIND OF RECORD THE AUTO-STOP AREA WAS OUT OF THE UNIT SETTING, SO IT WILL
STOP BEFORE THE LAST RACK FINISH. IN THIS CASE, SELECT THE AUTO-STOP SWITCH (26) TO " OFF
" POSITION, THEN IT WILL RUN TO THE END OF THE RECORD BUT WILL NOT STOP AUTOMATICALLY (TURN OFF
THE UNIT BY POWER BUTTON OR SWITCH BACK THE AUTO-STOP SWITCH TO " ON " POSITION TO STOP THE
PLATTER ROTATE). THEN PUT BACK THE TONE ARM TO THE REST POSITION.
" (TRACK SEPARATION) BUTTON ONCE AT REMOTE HANDSET DURING
OR SKIP BACKWARD
TO SELECT " YES " OR " NO ".
BUTTON TO SELECT THE FILE GOING TO DELETE
GB-7
OR SKIP