Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly and Installation (continued)
Connecting several deck lights with hardscape
5
adaptor
Use a Philips screwdriver to unscrew the screw connecting the foot base
□
(1) at the opposite end of the deck light (A) where the male plug (B) is
located. Twist off the foot base (1) from the deck light (A). Remove the
plastic plug (2). Replace the foot base (1) and rescrew it into place.
Repeat for all deck lights (A).
Depending on your installation requirements, refer to Steps 3 or 4 for the
□
installation of the individual fixtures.
After installation of all deck lights (A) is completed, insert the male plug
□
(B) on the second deck light into the electrical hole of the first deck light
[which was previously covered by the plastic plug (2)]. Repeat to connect
all of your deck lights (A) together in a daisy chain fashion. (You can
connect up to 9 deck lights (A).)
Insert the male plug (B) into the female plug (E).
□
Proceed to Step 8.
□
Connecting several deck lights without hardscape
6
adaptor
Twist off the foot base (1) from the deck light (A) at the opposite
□
end of the deck light (A) where the male plug (B) is located.
Remove the plastic plug (2). Replace the foot base (1). Repeat for
all deck lights (A).
Depending on your installation requirements, refer to Steps 2 or 3
□
for the installation of the individual fixtures.
After installation of all deck lights (A) is completed, insert the male
□
plug (B) on the electrical hole of the first deck light [which was
previously covered by the plastic plug (2)]. Repeat to connect all of
your deck lights (A) together in a daisy chain fashion. (You can
connect up to 9 deck lights (A).)
Insert the male plug (B) into the female plug (E).
□
Proceed to Step 8.
□
3
Publicidad
