Conel IW 1218VC0 Instrucciones De Funcionamiento Originales página 15

IW 1218VC0
Instructions for use
Before initial operation
 Unpack the power tool and accessories
and check that no parts are missing or
damaged.
 Attach the belt clip and bit holder with
the enclosed fastening screw.
Tool change
CAUTION!
Before carrying out any work on the power
tool, move the direction preselector switch (2)
to the middle position.
 Push adapter on square drive of impact
driver.
 Insert tool in adapter.
Inserting/replacing the battery
 Press the charged battery into the power
tool until it clicks into place.
 To remove, press the release button (1.)
and pull out the battery (2.).
CAUTION!
Protect the battery contacts when the
battery is not being used. Loose metal parts
may short-circuit the contacts –
Explosion and fire hazard!
Battery state of charge
 Press the button to check the state of
charge at the state of charge indicator
LEDs.
The indicator goes out after 5 seconds.
If one of the LEDs flashes, the battery must
be recharged. If none of the LEDs light up
after the button is pressed, the battery is
faulty and must be replaced.
15