Tristar WG-2418 Manual De Instrucciones página 18

manufacturing tolerances.
Inserting/ Changing Batteries:
The battery compartments of the scale and the remote control are both situated on the back. Before the first use,
open the battery compartments of both the scale and the remote control and insert four new "AAA" batteries and
two new "AAA" batteries respectively in the right polarity.
When " " or " " displays on the screen, it means the batteries of the remote control or of the scale are almost
exhausted respectively. Please replace with new batteries. If the figures appear and remain unchanged on the
display, re-insert the batteries and restart the scale.
Important:
When you change your batteries, be careful!!! You must dispose the batteries according to the regulations.
Dispose them in an appropriate place in order to assure their recycling and the protection of the environment.
Use of Electronic Infrared Body Fat and Water Scale
The body fat and water scale has two different operating modes:
Body weight measuring only
Body weight measuring with body fat and water analysis.
1.Body weight measuring:
(1) Gently touch the scale with your foot. The red LED display lights up. After approximately 2 seconds,
the LED turns green.
(2) Press the button
approximately 2 seconds, "HELO/0.0kg" or "HELO/0.0lb" will appear on the display. The scale is now
ready for use.
(3) Press the button
pounds).
(4) Stand still with barefoot on the scale and the measurement will begin.
When your weight is successfully established,a small " H
(5) If you remain on the scale, it will switch off after approximately 60 seconds. When you step off the
scales, the reading will return to "HELO/0.0kg" or "HELO/0.0lb". The scale is ready for weighing again.
(6) If a weight over 160kg or 352lbs is loaded onto the scale, "O-Ld" will be shown on the display.
2.Programming of the personal data
1.Press the button
button and hold it for 3 seconds, then "1-10" appears on the display. Release the button and a memory
number blinks on the display.
2.Press the buttons
memory "1" in your household and you partners may choose number "2". Confirm your selection by
to switch on the remote control, then "HELO/----" appears on the display. After
once only to change the measurement unit between kg (kilograms) and lb (British
to switch on the remote control, then "HELO/----" appears on the display. Press the
or to choose your desired memory slot. For example you may wish to use
H H " will show on the display.
Page 18 of 32