Publicidad
Idiomas disponibles
Idiomas disponibles
Front Panel Controls
POWER light indicator
To turn the TV ON, press the main power
switch located on the lower right side of the
TV. A red stand-by indicator lamp located on
the lower right corner of the front bezel will
illuminate. The Plasma TV is now ready for
remote ON/OFF operation.
Indicating Lamp Power Status
Off
OFF.
Lights
OFF.
Red
(Stand-by)
Lights
Blue
Lights
Orange
(Power Saving)
Blinking
On
Blue
REMOTE CONTROL sensor
Point your remote at this area when selecting
channels, adjusting volume, etc.
INPUT-FRONT JACKS
INPUT-FRONT provide composite Video jacks for
connecting equipment with this capability,
such as a DVD player or Camcorders.
NOTES:
1.
Your HITACHI Plasma TV will appear to be turned OFF (lights orange) if there is no video input
when INPUT : 1, 2, 3, Front or HDMI : 1, 2, Front is selected. Check the Power Light to
make sure the TV is turned off or in Stand-by mode (lights red) when not in use.
2.
Remote Control can not turn ON/OFF the "MAIN POWER" of the TV.
Operating
When the main power switch is set to Off.
When the main power switch on the TV is ON.
On
TV MAIN POWER is ON ; picture is shown.
TV MAIN POWER is ON with no signal input
Off
except antenna (no sync. signal).
When TV receives the IR signal from R/C.
Indicating Lamp
R/C sensor
13
Publicidad
