STA-RITE PoSi-Clear RP Guia De Instalacion página 7

Any time the filter tank is opened, and/or alement assembly is removed, be sure to generously coat the O-ring
with silicone lubricant before reassembling the unit. DO NOT USE PETROLEUM BASED LUBRICANTS BE-
CAUSE THEY HAVE A DETERIORATING EFFECT ON RUBBER.
12. Replace drain cap and reinstall High Flow™ manual air relief valve drain hose if used.
E. REPLACING CARTRIDGE ELEMENT
Cartridge element life will vary with pool conditions such as bather load, wind, dust, etc. You can expect an average
media life of three (3) years under normal conditions.
F. CLEANING THE HIGH FLOW™ MANUAL AIR RELIEF
VALVE
1. Turn the pump off and shut off any automatic controls to ensure
that the system is not inadvertently started during servicing.
2. OPEN THE HIGH FLOW™ MANUAL AIR RELIEF VALVE UNTIL
IT SNAPS INTO THE FULL OPEN POSITION, THEN WAIT
UNTIL ALL PRESSURE IS RELIEVED.
3. With the relief valve attached to the filter tank, pull out the locking
tabs and remove the valve stem and cover assembly with a
counterclockwise and lifting motion, see Figure 3.
4. Clean debris from the valve stem and body. Verify that the filter
tank's air passage is open by inserting a 5/16 in. drill bit through
the valve body. Verify that the O-ring are in good condition, properly
positioned, and lubricated with a silicone base lubricant.
5. Reinstall the valve stem and cover assembly with a downward and
clockwise motion until it snaps into position.
LIMITED WARRANTY : 2 YEARS
Further details : www.pentairpooleurope.com
NOTE
Figure 3.
7