Publicidad
Enlaces rápidos
M.T.M. Srl | Società Unipersonale
Via La Morra, 1 | 12062 Cherasco (Cn) | Italy
Tel. +39 0172 4860140 | Fax +39 0172 593113
info@brc.it | www.brc.it
Codice istruzione
Instruction code
Code d'instruction
Código instrucción
Versione
Version
Version
Versión
Codice kit
Kit code
Code kit
Código kit
Sistema
Costruttore
Builder
Constructeur
Constructor
Modello
Model
Modèle
Modelo
Cilindrata
Cubic capacity
Cylindrée
Cilindrada
Sigla motore
Engine type
Type de moteur
Código del motor
Petrol ECU
Euro
Cambio
Transmission
Transmission
Transmisión
DA ACQUISTARE SEPARATAMENTE/ TO BUY SEPARATELY
À ACHETER SÈPARÈMENT/ COMPRAR SEPARADAMENTE
KIT UGELLI CNG CON ESTENSIONE TUBO PTFE X COLLETTORI
09SQ99020053
CNG NOZZLES KIT, WITH PTFE EXTENSION PIPE FOR MANIFOLDS
KIT BUSES GNV AVEC RALLONGE TUYAU PTFE POUR COLLECTEURS
(x1)
KIT BOQUILLAS GNC CON ALARGADORA TUBO PTFE PARA COLECTORES
FSG000105R-1
n° 2 - 28/02/19
09SQ4SDIP083
SEQUENT DIRECT INJECTION 2.0
Suzuki
Vitara
1.4 cc - 16 V - 103 kW
K14C
BOSCH 0 261 S11 956 (658)
6D Temp
Manuale
Manual
Manuel
Manual
2.0
Lpg
Publicidad
Resumen de contenidos para BRC 09SQ4SDIP083
- Página 1 M.T.M. Srl | Società Unipersonale Via La Morra, 1 | 12062 Cherasco (Cn) | Italy Tel. +39 0172 4860140 | Fax +39 0172 593113 info@brc.it | www.brc.it Codice istruzione Instruction code FSG000105R-1 Code d’instruction Código instrucción Versione Version n° 2 - 28/02/19 Version Versión...
- Página 2 Filtro FJ1 HE Filter FJ1 HE E13*67R01*0168* Filtre FJ1 HE Filtro FJ1 HE Rail con 4 iniettori Normal BRC MY09 E13*67R01*0185* (Rail) Rail with 4 BRC MY09 Normal injectors E13*67R01*0262* (Sensor) Rail avec 4 injecteurs Normal BRC MY09 E13*67R01*0223* (Injectors)
- Página 3 Veuillez respecter les instructions suivantes pendant l’installation du système gaz: • Merci de vérifier sur notre site internet WWW.BRC.IT (“Espace Réservé”) la version et la date de cet instruction! • C’est la responsabilité du mécanicien de vérifier et respecter les normes nationales pour réaliser toutes modifica- tions nécessaires pour le montage.
- Página 4 Suzuki_Vitara 2X M8X14 M6X16 CH13 CH13 CH10 10±2 Nm 15±3 Nm M6X16 CH13 CH10 10±1 Nm 4|10 FSG000105R-1 M.T.M. Srl...
- Página 5 Suzuki_Vitara FISSAGGIO NUOVO ORIGINALE FISSAGGIO ORIGINAL FIXING FIXING Cyl. 1 Cyl. 2 Cyl. 3 Cyl. 4 INCLINAZIONE UGELLI GAS 0° 0° 0° 0° Coll. 1 Coll. 2 Coll. 3 Coll.4 Cyl. 1 Cyl. 2 Cyl. 3 Cyl. 4 L190 mm L190 mm L190 mm L220 mm...
- Página 6 Suzuki_Vitara Cyl. 4 Cyl. 3 Cyl. 2 Cyl. 1 25mm x4 CH10 10±1 Nm 10 Nm 6|10 FSG000105R-1 M.T.M. Srl...
- Página 7 Suzuki_Vitara 7|10 FSG000105R-1 M.T.M. Srl...
- Página 8 Suzuki_Vitara 4 mm 8|10 FSG000105R-1 M.T.M. Srl...
- Página 9 - Eseguire i collegamenti con saldature a stagno opportunamente isolate - Posizionare i dispositivi elettrici BRC in zona ben ventilata, al riparo da infiltrazioni d'acqua e da fonti di calore - Si raccomanda di isolare i fili della centralina BRC che non vengono collegati - BRC si riserva di modificare il presente schema senza alcun preavviso - Si consiglia di verificare di essere in possesso dell'ultima revisione di schema redatta dalla BRC.
- Página 10 Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity - Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.