Publicidad
Idiomas disponibles
Idiomas disponibles
SAFETY SUMMARY
1 SAFETY SUMMARY
HITACHI cannot anticipate every possible circumstance that might involve a potential hazard.
!
D A N G E R
•
DO NOT pour water into the remote controller. This product is
equipped with electrical parts. If poured, it will cause a serious
electrical shock.
•
DO NOT perform installation work and electrical wiring
connection by yourself. Contact your HITACHI distributor or
dealer and ask them for installation work and electrical wiring
by service person.
!
C A U T I O N
•
DO NOT install the indoor unit, outdoor unit, controller and cable at
such places as;
- Where there is oil vapor and the oil is dispersed.
- Where the hot springs are near (in a sulfuric environment).
- W heregeneration,flowing,stayingorleakingofflammablegasis
detected.
- Wheretheseaisnear(inthesaltyenvironment).
- Anacidoralkalineenvironment.
•
DO NOT install the indoor unit, outdoor unit, controller and cable
within approximately 3 meters from strong electro m agnetic wave
radiators such as medical equipment. In case that the controller is
installed in a place where there is electromagnetic wave radiation,
shield the controller and cables by covering with the steel box and
running the cable through the metal conduit tube.
•
Incasethatthereiselectricnoiseatthepowersourcefortheindoor
unit,provideanoisefilter.
•
Use specified cables to connect between indoor unit and remote
controlswitch.Selectingincorrectcablesmayleadtofireorelectrical
shock.
2 BEFORE INSTALLATION AND OPERATION
The packing contains the following parts. Check the contents and the number of the parts.
Name
Wireless remote control switch (controller)
Holding bracket
Batery (AAA/1.5 dry cell)
Screw
Installation and operation manual
3 SETTING BATTERIES
Set the batteries (AAA/1.5Vx2) for the controller as follows.
1 Remove the battery cover by sliding toward the arrow
direction by pushing the part of the cover as shown in the
figure below.
2 Set the batteries. (Insert the batteries according to the marks
of + and - on the case.)
!
C A U T I O N
Do not press the "
On"and"OnTimer"switchesuntilthepreparation
for Test Run is completed.
1
PMML0414A rev.2 - 11/2016 - P5416676
?
N O T E
•
Theinstallerandsystemspecialistshallcomplywithlocalregulations
orstandardsforthesafety.Thefollowingstandardsmaybeapplicable,
if local regulations are not available. International Organization for
Standardization, ISO5149 or European Standard, EN378 or Japan
Standard,KHKS0010.
•
Perform electrical work according to the Installation Manual.As for
theelectricalwiringworkandcheck,turnOFFthemainpowersupply
before opening/closing the service cover of indoor unit. If service
coverisopenedwithmainpowersupplylefton,itmayresultinan
electricalshock.
•
Itisassumedthatthiscontrolremotewillbeoperatedandservicedby
Englishspeakingpeople.Ifthisisnotthecase,thecustomershould
addsafetysuchasandoperatingsignsinthenativelanguagefornon
Englishspeakers.
•
This manual should be considered as a permanent part of the air
conditioningequipmentandshouldremainwiththeairconditioning
equipment.
•
This appliance must be used only by adult and capable people,
having received the technical information or instructions to handle
thisapplianceproperlyandsafely.
•
Childrenshouldbesupervisedtoensurethattheydonotplaywith
the appliance.
•
Important: read and understand this manual before using this remote
controller.
If you have any questions, contact your HITACHI distributor or
dealer.
Q'ty
1
1
2
For power source of controller
2
For fixing "Holding bracket" onto wall
1
Battery cover
Remark
For operation control
For controller
Slide the battery
cover toward the
arrow direction
with pushing
AAA Bateries
Publicidad
