KitchenAid 5KGM Manual Del Propietário página 4

PRODUCT SAFETY (CONTINUED)
17. This appliance is intended to be used in household and similar
applications such as:
- staff kitchen areas in shops, offices and other working
environments;
- farmhouses;
- by clients in hotels, motels and other residential type
environments;
- bed and breakfast type environments.
SAVE THESE INSTRUCTIONS
For complete details on product information, instructions and videos, including Guarantee
information, visit www.KitchenAid.co.uk or www.KitchenAid.eu. This may save you the cost
of a service call. To receive a free printed copy of the information online,
PRODUCT USAGE
BEFORE FIRST USE: CLEANING THE GRAIN MILL ATTACHMENT
IMPORTANT: The grinding burrs of the Grain Mill Attachment have been lightly coated with
mineral oil to help avoid rusting during storage. Before using the Grain Mill Attachment, wash
off the oil with a mild detergent solution and allow to dry thoroughly. If you do not remove the
oil, the burrs will become clogged and the grinding action will slow down. After using the Grain
Mill Attachment, follow the directions in the "Care and Cleaning" section.
1.
Hand-turn the screws to release the Front Plate with adjustment knob from the main body
of the Grain Mill Attachment.
2.
Remove the Power Shaft from the main body of the Grain Mill Attachment.
3.
Wash all parts by hand with mild detergent and warm water. Dry the main body thoroughly
with a towel. Allow the parts to air dry.
IMPORTANT: Do not wash the Grain Mill Attachment or any of its parts in an automatic
dishwasher.
4.
To reassemble: Insert the Power Shaft into the main body of the Grain Mill Attachment.
Then, mount the Front Plate onto the front of the shaft and hand-turn the screws into
place.
ATTACHING THE GRAIN MILL TO THE STAND MIXER
1.
Turn Stand Mixer to "0" (OFF) and unplug.
2.
For Stand Mixers with a hinged attachment hub cover: Flip up to open.
For Stand Mixers with a removable attachment hub cover: Turn the attachment knob
counterclockwise to remove the attachment hub cover.
3.
Insert the attachment shaft housing into the attachment hub, making certain the Power
Shaft fits into the square hub socket. If necessary, rotate the attachment back and forth.
The pin on the attachment housing fits into the notch of the hub rim when in the proper
position.
4.
Tighten the Stand Mixer attachment hub knob until the attachment is completely secured
to the Stand Mixer.
4
call 00 800 381 040 26.