Extremis picnik Serie Manual página 6

picnik
contents
1 x PicNik
optional: ground anchor kit
ground anchoring
To anchor the PicNik table to the ground,
4 of the 6 already mounted stainless steel
feet must be removed and replaced by the
4 stainless steel feet of the PFL04 ground
anchor kit.
1. Remove the protection caps of the
fastening screws of the 4 feet indicated on
the above drawing and loosen these screws
with a 5 mm Allen wrench.
4. Insert the fastening screws in the 4
ground anchor kit feet and fasten them with
a 5 mm Allen wrench. Put the protection
caps over the screws.
5. Now mark the spots on the ground where you want to anchor the table. Put the PicNik
table aside and drill holes at the indicated spots. Then anchor the PicNik table to the ground
using the supplied screws and plugs.
2. Remove the feet. 3. Replace them by the 4 new feet. The
side with the holes should always be facing
inwards.
www.extremis.be