Publicidad
PRESSURE WASHER QUICK SET-UP
1
REMOVE THE PRESSURE WASHER AND ALL ITEMS
FROM THE PACKAGING.
2
A
B
3
4
5
THREAD THE SPRAY LANCE ON TO THE GUN WAND
AND TIGHTEN BY HAND.
6
PLACE NOZZLES, HOSE AND SPRAY GUN WAND IN
THEIR RESPECTIVE STORAGE LOCATIONS.
START-UP PROCEDURE
2 2
1 1
CHECK YOUR
FLUID LEVELS.
GARDEN HOSE
TO PUMP INLET.
7 7
8 8
MOVE GAS
SWITCH ENGINE
VALVE TO THE
RIGHT.
SLIDE THE FRAME HANDLE
ASSEMBLY (A) ONTO
THE PRESSURE WASHER
ASSEMBLY POSTS (B).
SLIDE BOLTS INTO THE HOLES
WITH THE BOLT HEX FITTING
INTO THE HEX SHAPE
CUT-OUT.
THREAD ON THE PLASTIC
FASTENERS AND TIGHTEN BY
HAND.
3 3
CONNECT
CONNECT HIGH-
PRESSURE HOSE
TO THE PUMP
OUTLET.
9 9
PULL RECOIL
UNTIL ENGINE
TO "ON".
STARTS.
SCAN THE QR CODE TO
VIEW THE B347RX
START-UP PROCEDURE
ENGINE FUEL AND OIL
THIS PRESSURE WASHER COMES WITHOUT
FUEL OR OIL IN THE ENGINE.
THIS MACHINE WILL NOT START UNTIL
FUEL AND OIL ARE ADDED.
CHECK YOUR FLUID LEVELS BEFORE EACH USE.
USE REGULAR UNLEADED GASOLINE WITH AT
LEAST 87 OCTANE AND WITH NO MORE THAN
10% ETHANOL CONTENT.
USE THE PROVIDED SAE 10W30 ENGINE OIL. TO
FILL OIL, FOLLOW THESE STEPS:
1 1
2 2
*REFER TO PAGE 10 OF THE MANUAL FOR FURTHER DETAILS.
*PRESSURE WASHER PUMP DOES NOT REQUIRE OIL.
! ATTENTION !
ALWAYS FOLLOW THE PROPER STORAGE PROCEDURE TO
HELP PREVENT FAILURES
*SEE PAGE 18 IN THE USER MANUAL FOR STEPS
4 4
5 5
CONNECT SPRAY
TURN ON WATER
GUN TO HIGH-
SUPPLY & PURGE
PRESSURE HOSE.
AIR FROM SYSTEM.
SHUT DOWN PROCEDURE
10
10
1 1
SWITCH ENGINE
MOVE CHOKE
TO THE RIGHT
(RUN).
REMOVE THE OIL CAP
WITH THE DIPSTICK AND
THEN USE THE PROVIDED
FUNNEL TO POUR THE OIL.
CHECK OIL LEVEL ON
THE DIPSTICK TO ENSURE
CORRECT LEVEL.
6 6
MOVE CHOKE &
THROTTLE TO
THE LEFT.
2 2
PURGE WATER
TO "OFF".
FROM SYSTEM.
85.610.840EN
Publicidad
