Philips FC8130 Manual Del Usuario página 7

- Children should be supervised to ensure that they do not play with the appliance.
- Do not point the hose, the tube or any other accessory at the eyes or ears nor put it in your
mouth when it is connected to the vacuum cleaner and the vacuum cleaner is switched on.
Caution
- Do not suck up large objects as this may cause the air passage in the tube or hose to become
obstructed.
- When you use the vacuum cleaner to vacuum ashes, fine sand, lime, cement dust and similar
substances, the pores of the dustbag and the motor protection filter become clogged. If you
notice a strong decrease in suction power, replace the dustbag and clean the motor protection
filter.
- Always unplug the appliance before you replace the dustbag or clean the filters.
- Never use the appliance without a dustbag or the motor protection filter. This could damage the
motor and shorten the life of the appliance. We advise you to use Philips s-bag ® double-layer
paper dustbags.
Electromagnetic fields (EMF)
This Philips appliance complies with all standards regarding electromagnetic fields (EMF). If handled
properly and according to the instructions in this user manual, the appliance is safe to use based on
scientific evidence available today.
preparing for use
hose
1 To connect the hose, push it into the appliance ('click') (Fig. 2).
2 To disconnect the hose, press the release buttons (1) and pull the hose connector out of the
hose connection opening (2). (Fig. 3)
telescopic tube
1 To connect the tube to the handgrip of the hose, insert the narrow section into the wider
section while turning a little (Fig. 4).
To disconnect the tube, pull while turning a little.
2 Adjust the telescopic tube to the length you find most comfortable during vacuuming. Press
the slide on the tube (1) and push the lower tube part downwards or pull it upwards
(2) (Fig. 5).
Combination nozzle
You can use the combination nozzle on carpet (with the brush strips folded in) or on hard floors
(with the brush strips folded out).
- To clean hard floors, push the rocker switch on top of the combination nozzle with your foot to
make the brush strips come out of the nozzle housing. (Fig. 6)
- To clean carpet, push the rocker switch on the other side to make the brush strips disappear
into the housing. (Fig. 7)
hard floor nozzle (specific types only)
- The hard floor nozzle is designed for gentle cleaning of hard floors (Fig. 8).
accessory holder
You can store two accessories in the accessory holder at the same time.
1 Connect the accessory holder to the tube (1) and then connect the hose to the accessory
holder (2) (Fig. 9).
English
7