Publicidad
Idiomas disponibles
Idiomas disponibles
3.3.1.
Installing the engraving tip
WARNING! Before performing any adjustment or maintenance activities, disconnect the device from the
power source.
a)
Loosen the tip release screw (4) by turning it counterclockwise with a flathead screwdriver.
b)
To install a new engraving tip (2), insert the tip through the center of the engraving machine hole,
making sure that the tip is fully inserted into the housing. The new tip should protrude approximately
8.5 mm from the end of the housing.
c)
Tighten the tip release screw (4) fully by turning it clockwise.
3.3.2.
Operation
WARNING! Always wear safety glasses when using this tool.
a) Before using the machine, make sure that the engraving tip is installed.
b)
Connect the appliance plug to the power supply and, holding firmly, press the main on/off switch (1)
with your thumb.
CAUTION! To turn on the tool, press the main switch (1) upwards to position (I). To turn off the tool, press
the main switch (1) down to position (O).
Hold the device at an angle, just like holding a pen. Do not press hard when engraving, use light pressure
while guiding the tip over the work in progress.
3.3.3.
Adjusting the depth of engraving
a) The stroke adjustment knob (3) on the side of the machine controls the stroke length and the engraving
depth.
b)
To obtain a precise mark, turn the stroke adjustment knob (3) counterclockwise to the "1" position.
c)
To obtain a deeper, thicker mark, turn the stroke adjustment knob (3) clockwise to the "5" position.
d)
CAUTION! Before starting work, it is recommended to practice the engraving settings on the item
intended for trash.
3.4.
Cleaning and maintenance
a)
Pull the mains plug and let the unit cool down completely before cleaning, adjusting or replacing
accessories and when the unit is not in use.
•
Wait until the rotating parts stop.
b)
Use only non-corrosive cleaning agents for cleaning the surfaces.
c)
Store the unit in a dry and cool place protected from moisture and direct sunlight.
d)
Do not spray the unit with a stream of water or immerse it in water.
e)
Make sure that no water enters through the ventilation openings in the casing.
f)
Clean the ventilation openings with a brush and compressed air.
g)
Perform regular inspections of the unit checking technical fitness and any damages.
h)
Use a soft, damp cloth for cleaning.
i)
Do not use sharp and/or metal objects (e.g. wire brush or metal spatula) as they may damage the surface
of the material from which the appliance is made.
j)
Do not clean the unit with acidic substances, medical agents, thinners, fuel, oils, or other chemicals. It
may cause damage to the device.
DISPOSAL OF USED UNITS.
At the end of its useful life, this product should not be disposed of with normal household waste but should
be taken to a collection point for the recycling of electrical and electronic equipment. This is indicated by
the symbol on the product, operating instructions, or packaging. The materials used in this appliance are
EN
Publicidad
