Publicidad
Seat_Arona
2.0
Fuse
Fuse
5A
15A
Relé
Gas
Inlet
LPG EV
WARNING:
- Follow carefully petrol and gas injectors sequence as shown in the diagram.
- Never connect front and back Solenoid Valve cables to the Ground.
- In order to make a front and back Solenoid Valve right diagnostic, don't connect them to each other.
- Never replace fuses with another ones with bigger amperage.
CAUTION:
Be careful with the cars for which the manufacturer prohibits or advises against disconnecting the battery, not to alter the antitheft devices or automatic adaptivity -
Never use welders connected to the battery of the same car - Connect with suitably insulated soft solderings - Position the BRC electrical devices in a well ventilated
area, protected from water seepages and heat sources - We recommend to insulate the BRC electronic control unit wires which are not connected - BRC reserves the
right to modify this diagram without notice - We also recommend you to be sure to have the last revision of the diagram drawn up by BRC.
M.T.M. Srl
SEQUENT DIRECT INJECTION 2.0
Seat Arona TSI 1.0 12 V 85 kW CHZJ GPL
Multipoint Electronic Injection
Changeover
Switch
Cut and
Insulate
Singularly
Gas Pressure
1
2
3
and
Temperature
Sensor
Gas Injectors Sequence
Wiring Diagram
Diagnostic
Point
Red
3
2
1
Black
Black
Black
Red
Red
+
Cut and
Insulate
Singularly
Pin n° 87 Conn. K - 94 Pin
Pin n° 67 Conn. K - 94 Pin
Pin n° 68 Conn. K - 94 Pin
Pin n° 5 Conn. A - 60 Pin
Pin n° 10 Conn. A - 60 Pin
Pin n° 47 Conn. A - 60 Pin (1° Injector Signal)
Pin n° 31 Conn. A - 60 Pin (1° Injector Positive)
Pin n° 32 Conn. A - 60 Pin (2° Injector Signal)
Pin n° 18 Conn. A - 60 Pin (2° Injector Positive)
Pin n° 33 Conn. A - 60 Pin (3° Injector Signal)
Pin n° 48 Conn. A - 60 Pin (3° Injector Positive)
Sensor
temperature
water
DO NOT CONNECT
1 2 3 4
7|7
Date:
Diagram n°:
In place of diagran n°:
Draftsman.:
Signature:
Level sensor connector
Cut and insulate
Rear solenoid valve connector
-
Battery
Attenzione: la connessione del CAN BUS
NON può esser effettuata a livello
presa diagnosi, ma DEVE esser effettuata
a livello connettore centralina benzina
Petrol
ECU
Pin n° 8
Conn. A - 60 Pin
White (MAP)
Map sensor
DO NOT CONNECT
Petrol
Injectors
Sequence
07_03_19
-
//.//.//
I.C.
fusibili
MV
FSM000029R
Publicidad
