Publicidad
Idiomas disponibles
Idiomas disponibles
- Always discard any breast milk that is left over at
the end of a feed.
- Do not use abrasive cleaning agents or anti-
bacterial cleaners. Do not place components
directly on surfaces that have been cleaned with
anti-bacterial cleaners.
- Plastic material properties may be affected by
sterilizing and high temperatures. This can affect the
fit of the cap.
- Inspect before each use and pull the feeding teat
in all directions.Throw away any part at the first
signs of damage or weakness.
- Do not alter the product or parts of it in any way.
This may result in unsafe functioning of the product.
Before first and every use
Disassemble all parts and clean them in warm soapy
water and rinse them thoroughly. Sterilize the parts
in boiling water for 5 minutes or by using a Philips
Avent sterilizer. This is to ensure hygiene. During
sterilizing in boiling water, make sure that the pan
contains enough water and prevent the bottle or
other parts from touching the side of the pan. This
can cause irreversible product deformation, defect
or damage that Philips cannot be held liable for.
Make sure that you wash your hands thoroughly
and that the surfaces are clean before contact with
sterilized parts. Place all bottle parts on a clean
paper towel or on a clean drying rack and allow them
to air dry. Excessive concentration of detergents
may eventually cause plastic components to crack.
Should this occur, replace immediately. This product
is dishwasher safe - food colourings may discolour
parts. Clean and sterilize all parts before each use.
For hygiene reasons, we recommend replacing teats
after 3 months.
Publicidad
