König Electronic HC-WBT10 Manual página 3

Brushing: 2 Minutes
1. Press the Brush Button. The LED light will
illuminate green and begin to blink.
2. Brush your teeth using your favourite
toothpaste as the green LED Light/Timer is
EOLQNLQJ7KHVSHHGRIWKHJUHHQÀDVKLQJOLJKW
indicates your progress.
3. The LED will turn red when the time is up.
NOTE: If you accidentally press the wrong button,
simply press the rest button to reset the unit.
Mounting the Timer
Hook and Loop Tape (included):
1. Check the location of where you want to place
the Timer. Make sure it is clean and that there
is no dust.
2. Remove the suction cup from the back of the
bracket by sliding it down and pulling it away
from the bracket.
3. The two sides of the hook and loop tape come
pre-attached for ease of mounting. Remove
the paper covering on one sticky side of the
tape.
NOTE: Hook and loop tape may be cut to desired
size for easier removal.
4. Place the tape in the recessed area in the
centre at the back of the Mounting Bracket.
5. Remove the paper covering on the other
sticky side of the tape.
6. Place the Mounting Bracket in the desired
ORFDWLRQ3UHVV¿ U PO\ DQGKROGIRU¿ Y H
seconds so that the tape adheres to the
surface.
CAUTION: Be cautious of what surface the hook
and loop adhesive is attached to, as it may remove
paint or damage the surface.
3