Important; Technical Information - Virutex FC116U Manual De Instrucciones

18 - FC116U / Operating instructions
FC116U LOCK MORTISER

IMPORTANT

Read these OPERATING INSTRUCTIONS and the attached GENE-
RAL SAFETY INSTRUCTIONS LEAFLET carefully before using the
machine. Make sure you have understood them before operating
the machine for the first time. Keep both sets of instructions for
any future queries.

1. TECHNICAL INFORMATION

Universal motor.............................................................................50/60 Hz
Power................................................................................................1,100 W
No-load speed..........................................................................23,000 min
Maximum bit diameter....................................................................30 mm
Maximum trimming depth......................................................0-125 mm
Maximum trimming width...................................................bit diameter
Maximum trimming length.................................177 mm + bit diameter
Maximum opening of the clamp vises........................................190 mm
Maximum grip of the clamp vises....................................................13 mm
Side movement of the bit over thickness of door...........+/- 15 mm
Weight...................................................................................................14 Kg
Weighted equivalent continuous acoustic pressure level A......87 dBA
Acoustic power level A.........................................................................98 dBA
Uncertainty......................................................................................K = 3 dbA
Wear ear protection!
Vibration total values............................................................a
Uncertainty................................................................................K: 1.5 m/s
2. USE
The FC116U portable lock mortiser is an electrical tool, for the
trimming of mortises to mount door locks, mortise assemblies,
etc.
In addition to the box for the lock, you can also trim the fitting
for the front plate of the lock. With the help of the tool UC16I,
which comes with the equipment, you can drill the entry points
in the door for the cylinder and the handle.
-1
: <2.5 m/s 2
h
2