Descargar Imprimir esta página

EINHELL RT-VC 1600 E Manual De Instrucciones Original página 11

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 45
Anleitung_RT_VC_1600_E_SPK1:_
Air regulator (Fig. 1/17)
The air regulator (17) can be fitted between the
suction hose (11) and the suction tube (20). The
suction power of the nozzle can be infinitely adjusted
using the air regulator (17).
5.4 Suction nozzles
Dual-purpose nozzle (Fig. 1/13)
For dry vacuuming surfaces use the dual-purpose
nozzle (13).
Crevice nozzle (Fig. 1/21)
The crevice nozzle (21) is designed for vacuuming
solids and liquids in corners, edges and other areas
that are difficult to access.
Upholstery nozzle (Fig. 1/22)
For cleaning upholstery use the upholstery nozzle
(22).
5.5 Automatic cable rewind (Fig. 11/18)
The wet and dry vacuum cleaner is fitted with an
automatic cable rewind (18).
Before using:
Pull the power cable out of the vacuum cleaner
slowly and evenly.
After using:
With one hand actuate the pushbutton of the
automatic cable rewind (18), with the other hand
guide the power cable while it is being pulled into the
appliance by the automatic cable rewind.
5.6 Storage compartment (Fig. 12/19)
The wet and dry vacuum cleaner is fitted with an
storage compartment (19) for accessory equipment.
Swing the storage compartment (19) towards the
front to open.
5.7 Accessory holder (Fig. 12/25)
The wet and dry cleaner is equipped with a holder for
the space-saving storage of vacuum nozzles.
5.8 Vacuum tube holder (Fig. 13/24)
Insert the vacuum tube into the vacuum tube holder
(24) as shown in the illustration.
24.08.2009
10:35 Uhr
Seite 11
6. Operation
6.1 ON/OFF switch (Fig. 1/2)
Switch position 0:
Switch position I:
Suction power control: (Fig. 1/6)
The wet and dry vacuum cleaner is fitted with a
suction power control.
Reducing the suction power:
Turn the rotary knob for regulating the suction power
(6) counter-clockwise.
Increasing the suction power:
Turn the rotary knob for regulating the suction power
(6) clockwise.
6.2 Dry vacuuming
For dry-vacuuming, use the pleated filter (15). In
addition, you can also fit the dirt bag. (see point 5.2)
Always ensure that the filters are perfectly secure.
6.3 Wet vacuuming
For wet-vacuuming, use the foam filter (16) (see point
5.2).
Check that the filter is securely fitted at all times.
Important!
When wet vacuuming, the floating safety switch (5)
turns off the wet and dry vacuum cleaner
automatically when the maximum level is reached.
Important!
The wet and dry vacuum cleaner is not suitable for
the vacuuming of combustible liquids.
For wet vacuuming, use only the supplied foam filter.
Water drain screw (Fig. 14/12)
To make the tank (8) easier to empty after wet
vacuuming, it is fitted with a water drain screw (12).
Open the water drain screw (12) by turning it anti-
clockwise and drain the liquid.
6.4 Blowing
Connect the suction hose (11) to the blow connector
(10) on the wet and dry vacuum cleaner.
GB
Off
On
11

Publicidad

loading

Este manual también es adecuado para:

23.420.81