Setup Menu - Panasonic SC-HTE80 Instrucciones De Funcionamiento

3D CLR The 3D Clear Mode Dialog feature
DIALOG creates a sound field similar to the
sound coming from a TV screen and
makes dialogues clearer.
ON: 3D Surround, Clear Mode Dialog
and Dolby Virtual Speaker effect
OFF: Dolby Virtual Speaker effect
The setting is set back to "ON" every
time you switch on the system.
DUAL AUDIO Sets the preferred audio channel
mode when there are two audio
modes received by the unit.
M1: Main
M2: Secondary
M1 + M2: Main + secondary
This effect only works if the audio
output of the TV or player is set to
"Bitstream" and "Dolby Dual Mono" is
available in the sound source.
AGC Auto gain control prevents sudden
loud sound by reducing the sound
level automatically when the input is
too high.
ON
OFF
LOW VOL Enhance the dialog in low volume
MODE condition.
ON
OFF
Select "OFF" to cancel this effect if the
dialog does not sound natural in low
volume condition.
Note:
The default setting is underlined. Changed settings will
be kept until it is changed again, unless otherwise
indicated.
Audio format
You can view the current audio format.
Press and hold [SOUND] for a minimum of
4 seconds.
DOLBY Dolby Digital is the audio source.
DIGITAL
DTS DTS is the audio source.
PCM MULTI Linear pulse-code modulation is the
audio source.
PCM 2 channel pulse-code modulation is
the audio source.
ANALOG Analog is the audio source.
SBC Sub-band Coding is the audio source.
(Bluetooth mode only)
®

Setup Menu

1
Press [SETUP] repeatedly to select the setup
item.
2
Press [R, T] repeatedly to select the desired
setting and then press [OK].
DIMMER Dims the display panel after
5 seconds of inactivity.
ON
OFF
AUTO POWER The system automatically switches off
DOWN if there is no audio input and when you
do not use it for 2 hours.
ON
OFF
VOL Sets the volume limit to 50 when you
LIMITATION switch on the system although the
volume is set to above 50 before it is
switched off.
ON
OFF
BLUETOOTH This function allows you to connect a
STANDBY paired Bluetooth device when this
®
system is in standby mode.
ON
OFF
The system will switch on
automatically when you connect a
paired Bluetooth device.
®
LINK MODE Change the Bluetooth
link mode to suit the connection type.
Make sure to disconnect the current
connected device ("BLUETOOTH
READY" is shown).
MODE 1: Emphasis on connectivity.
MODE 2: Emphasis on sound quality.
VIERA LINK Switch on the VIERA Link function.
ON
OFF
Select "OFF" when your HDAVI
Control device does not work correctly
with this system. ARC will be disabled.
Connect an optical digital audio cable.
Switch off all connected devices and
then switch them on again after
changing the setting.
Note:
The default setting is underlined. Changed settings will
be kept until it is changed again, unless otherwise
indicated.
connection
®
9
9