USING YOUR FRYER
1. INTRODUCING THE OIL OR FAT
l Open the top lid.
l Lift the basket using the handle.
l Place approximately 1.1 liters of oil or 0.7 kg of hard fat into the fryer body (the level must
always be between the two marks on the oil container wall).
l If you use blocks of fat, cut them into pieces before placing them in the body.
l Set switch of the temperature controller to 140 ℃ (the red Indicator light comes on). To
melt the fat needs roughly 8 minutes.
l Never attempt to melt fat in the basket.
2. COOKING
l Plug in the fryer; the indicator "POWER" comes on.
l Set the temperature controller to the desired temperature depending on what you are
going to cook, the indicator "HEAT" comes on.
l When the indicator "HEAT" goes out (after approx. 5-7 minutes) the fryer has reached the
corresponding temperature. Open the top lid.
l Attach the handle into basket and use the handle protection.
l Put the food in the basket.
l Lower the basket into the oil slowly; watching the oil level and foam in order to keep them
from reaching the fringe of the oil container confirming the oil level is appropriate. Detach
the handle. Close the lid.
l When the food is cooked, turn anticlockwise the temperature controller to the position
"OFF"; the indicator "HEAT" goes out. Unplug the fryer or shut the power socket; the
indicator "POWER" goes out. Open the lid. Attach the handle to basket's support (at the
top of the basket's body), raise the basket and drain the oil.
l When cooking, the temperature controller will heat or stop heating according to the set
temperature; the "HEAT" indicator light will flicker.
CLEANING
• Unplug the appliance when cleaning.
• Wait until the oil or fat is cold before cleaning.
• Solid fat should not be allowed to solidify completely.
• Remove the basket and drain the oil fat.
• Clean the outside of the fryer and the lid with a damp
cloth.
• Never use abrasive pads or alcohol.
• Detach the handle from the basket.
• Wash the basket with hot water or washing-up liquid.
Rinse and dry carefully.
• Never immerse the appliance in water or wash it directly