Descargar Imprimir esta página

Lacme EasyStop P200 Instrucciones De Empleo página 4

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

You have purchased a fence energiser and thank you for your confidence.
This energiser meets international safety standards and is approved by the French Ministry of Agriculture.
It works thanks to a 9 V fence battery not supplied (9 V connection cable supplied). It can also be powered using a 12V
battery or the mains supply with the Lacmé AC Adapter (not supplied).
This logo confirms that you can power your energiser with an AC adapter.
Only the mains adaptor supplied by LACME
For safety reasons, this energiser must never be connected with any other mains adaptor.
The mains adaptor supplied by LACME must not be used with an energiser from another manufacturer, or with any other
LACME model not designed for this purpose (if in doubt, refer to the guide provided with your energiser).
When using the adapter make sure it is safe from moisture, ideally on an inside wall.
Never use the AC adapter together with a 9V battery.
The technology called "low impedance" allows the fence to remain effective even if losses occur grass touching the wire,
broken insulators...).
A green flashing operating LED is used to check the correct operation of the device.
A "low battery" LED flashes red when 20% battery life is remaining."
Operation LED
Low Battery
EasyStop P200
USAGE :
Connect the high voltage terminal of the energiser to the fence line
Connect the output terminal "ground"of the energiser to the earth stake
These connections (both earth and high voltage) must be made using insulated wire 20 000 V,
GALVA or FISALU. Otherwise the effectiveness of the fence could be greatly altered.
The grounding of the fence should be separated by at least 10 m from a domestic earth (home electricity supply).
Check all connections ensure good electrical contact. Knots or other splices can be a source of bad contact and thus
cause conductivity degradation and loss of efficiency.
Press the ON / OFF switch on the front of the energiser: the indicator light should light with each pulse (approximately
every 1.5 s). Attention, this light does not guarantee that the voltage and energy levels are sufficient to correctly
guard the animals. Only regular checks using a controller on the fence line can ensure this.
EasyStop P200
(Réf. : 624 000)
Delivered
Mains supply
power (J)
OUT
9 V/12 V
0,2
110 V/230 V
EasyStop P200
is allowed to be used with this energiser.
ON/OFF
Voltage(V)
Voltage(V) /
/ 500 ohm
1 000 ohm
(strong
(medium
vegetation)
vegetation)
2 300
3 600
L x W x H : 26 x 16 x 27 cm - Weight : 1,1 kg
4
Voltage
power usage
peak (V)
(mA)
10 500
39
24
type
FISOL, FISOL
EN
Impulses/
minute
40

Publicidad

loading