Publicidad
Idiomas disponibles
Idiomas disponibles
Impact Connect
DT20560
Congratulations!
You have chosen a D
WALT tool. Years of experience, thorough
e
product development and innovation make D
most reliable partners for professional power tool users.
Technical Data
WARNING: Cold pipes could result in flying debris of PVC.
DT20560 is intended to be connected to Impact Drivers only. "
DT20560
Max pipe diameter
Materials To Be Cut
The pipe cutter DT20560 is optimized for DEWALT Impact
Drivers and compatible with select other branded pro-grade
Impact Drivers.
Mass not exceeding 2kg
Torque between 135Nm and 280Nm
Speed between 2500/min and 4000/min
WARNING: To reduce the risk of injury, read the
instruction manual.
Definitions: Safety Guidelines
The definitions below describe the level of severity for each
signal word. Please read the manual and pay attention to
these symbols.
DANGER: Indicates an imminently hazardous
situation which, if not avoided, will result in death or
serious injury.
WARNING: Indicates a potentially hazardous situation
which, if not avoided, could result in death or
serious injury.
CAUTION: Indicates a potentially hazardous situation
which, if not avoided, may result in minor or
moderate injury.
NOTICE: Indicates a practice not related to
personal injury which, if not avoided, may result in
property damage.
Denotes risk of electric shock.
Denotes risk of fire.
The vibration and/or noise emission level can be expected
equally or lower than the value as given in the information sheet
of the used impact driver. These values have been measured in
accordance with a standardised test given in EN62841 and may
be used to compare one tool with another. It may be used for a
preliminary assessment of exposure.
WARNING: The declared vibration and/or noise emission
level represents the main applications of the tool. However,
PVC/PEX Cutter
®
WALT one of the
e
mm
60.3
PVC, uPVC, cPVC and PEX
Type A, B, and C
if the tool is used for different applications, with different
accessories or is poorly maintained, the vibration and/or
noise emission may differ. This may significantly increase the
exposure level over the total working period.
An estimation of the level of exposure to vibration and/or
noise should also take into account the times when the tool is
switched off or when it is running but not actually doing the
job. This may significantly reduce the exposure level over the
total working period.
Identify additional safety measures to protect the operator
from the effects of vibration and/or noise such as: maintain
the tool and the accessories, keep the hands warm (relevant
for vibration), organisation of work patterns.
EC‑Declaration of Conformity
Machinery Directive
PVC/PEX CUTTER
DT20560
D
WALT declares that these products described under Technical
e
Data are in compliance with:
2006/42/EC, EN 62841-1:2015 + AC:2015 + A11:2022.
For more information, please contact D
address or refer to the back of the manual.
The undersigned is responsible for compilation of the technical
file and makes this declaration on behalf of D
Markus Rompel
Vice-President Engineering, PTE-Europe
D
WALT, Richard-Klinger-Straße 11,
e
65510, Idstein, Germany
2023.02.01
DECLARATION OF CONFORMITY
THE SUPPLY OF MACHINERY (SAFETY)
REGULATIONS 2008
PVc/PEX cutter
D
WALT declares that these products described under "technical
e
data" are in compliance with:
EN 62841-1:2015 + AC:2015 + A11:2022
These products conform to the following UK Regulations
The Supply of Machinery (Safety) Regulations, 2008, S.I.
2008/1597 (as amended).
WALT at the following
e
WALT.
e
DT20560
EnGLIsh
17
Publicidad
