Adjusting The Picture Tone In A Multi-Camera System; Connecting The Cameras To Video Equipment With Phase Indication Capability; Connecting The Cameras To Video Equipment Without Phase Indication Capability - Sony ExwaveHAD DXC-C33 Instrucciones De Uso

White balance adjustment errors
If the auto white balance adjustment is not
successful, an error message appears on the
screen. If this happens, take the necessary
measures and perform steps 1 through 8
again.
For more details, see "List of Messages" on
page 41.
WHITE:
XXXXX
Error message
Adjusting the Picture Tone in
a Multi-Camera System
When configuring a multi-camera system,
adjust all cameras to prevent camera-to-
camera variations in picture tone.
Before making the adjustments outlined
below, input the same sync signal to all
cameras.
For connections, see "Connecting Two or
More Cameras — Multi-Camera System" on
page 34.
Connecting the cameras to video
equipment with phase indication
capability
When connecting to a special-effects
generator, a chroma-key unit, or other video
equipment with phase indication capability,
the basic adjustment procedure is as follows:
1
Turn on the phase indication
capability of the connected video
equipment.
2
Select H. PHASE from EXT SYNC in
the SYSTEM menu, and adjust the
horizontal phase.
NG
For more details, see "SYSTEM Menu"
on page 22.
3
Select SC. PHASE from EXT SYNC
in the SYSTEM menu, and adjust the
subcarrier phase.
First adjust the subcarrier phase roughly
with SC. PHASE ROUGH set to 0° and
180°, then adjust it finely using SC.
PHASE FINE.
For more details, refer to the instruction
manual of the connected video
equipment with phase indication
capability.
Connecting the cameras to video
equipment without phase
indication capability
Use one of the cameras as a reference
camera and adjust the other cameras to the
reference camera one by one.
1
Adjust the horizontal phase. Select
H. PHASE from EXT SYNC in the
SYSTEM menu, and adjust so that the
reference video signal and the output
signal have the same horizontal sync
phase. Use a waveform monitor or an
oscilloscope to check the phase.
2
Adjust the subcarrier phase. Select
SC. PHASE from EXT SYNC in the
SYSTEM menu.
First adjust the subcarrier phase roughly
with SC. PHASE ROUGH set to 0° and
180°, then adjust it finely using SC.
PHASE FINE so that the reference video
signal and the output video signal have
the same subcarrier phase. Use a
vectorscope or the wiping function of a
special-effects generator to display the
images of both the reference camera and
the camera to be adjusted
simultaneously on the screen.
27
GB
Shooting