Taurus SLIDING X-PRO 7.5 Instrucciones De Uso página 10

TROUBLE SLUTION
PROBLEM
Water drips from the sole.
Steam/water comes out of the
calcifi cation fi lter cap.
Dirty water comes out of the
sole
No steam comes out of the
sole.
The iron leaves a shiny mark on
the clothes.
The ironing centre does not
produce steam.
Low steam
The ironing centre produces a
pumping sound.
The ironing centre generates
a strong, intermittent pumping
sound.
SSB2800_MANUAL.indb 11 SSB2800_MANUAL.indb 11
POSSIBLE REASON
The residual steam in the
steam hose has cooled down
and condensed.
The calcifi cation fi lter cap is not
properly closed.
Impurities or chemicals present
in the water may have deposi-
ted in the steam ducts and/or
boiler plates.
Too much limescale and mine-
rals have built up in the steam
generator.
The surface to be ironed is
uneven. For example: seams or
folds of clothes.
There is not enough water in
the tank (the low water warning
light comes on).
The water tank is not perfectly
positioned.
The boiler is not hot enough to
generate steam.
This is normal as the centre
pumps water to the steam
generator.
Not enough water in the tank
(low water warning light comes
on).
SOLUTION
Place the iron on the base
and leave to steam for a few
minutes
Turn off the appliance and let it
cool down for at least 2 hours.
Unscrew the cap of the anti-
scale fi lter and insert it again.
Note: when unscrewing the cap,
some water will come out of the
fi lter, so it is recommended to
keep a container at hand.
Use distilled water. Clean the
soleplate and the boiler as
described in the corresponding
chapters.
Clean the boiler as described in
the respective sections.
Avoid ironing seams or folds.
Put a piece of cotton cloth on
the ironing area to avoid leaving
a mark.
Fill the water tank and press
the steam trigger to heat up the
appliance again.
Put the water tank back in until
you hear a "click".
Wait until the iron ready indica-
tor LED stops fl ashing.
If the pumping sound conti-
nues, switch off and unplug the
ironing centre.
Fill the water tank and press the
steam trigger to let the applian-
ce heat up again.
When the "iron ready" indicator
light stops fl ashing you can
continue ironing.
13/10/2022 13:03:20 13/10/2022 13:03:20