Taurus SLIDING CARE FORCE 2200 Instrucciones De Uso página 9

Downloaded by: pd-oliana on 11-08-2022 08:48 CEST
USE:
Extend the cable completely before plugging
it in.
Connect the appliance to the mains.
Press the power button (G) and choose the
desired steam level by pressing the steam
level selection button (H). At this moment the
indicator light will flash.
After 60 seconds the steam light will remain
on indicating that the preheating process is
finished.
Press the steam button (D) once to start
steaming.
Direct the appliance to direct the flow of steam
in the desired direction.
NOTE: It is not necessary to keep the steam
button pressed to have steam. When you do
not want any more steam, press the steam
button again to finish steaming. It will take
10 to 25 seconds for the appliance to stop
steaming completely.
STEAMING GARMENTS
The steam garment is easy to use and is
perfect for removing wrinkles/creases from
garments and curtains as well as refreshing
furnishings fabrics
It can be used on most fabric as long as
the fabric is hanging or where the garment
steamer can be easily used in an upright
position moving over the fabric in an up and
down motion.
NOTE: This garment steamer is designed
to be used in a vertical position on hanging
garments or horizontally on garments placed
on an ironing board.
Hang the garment from a hanger and stretch
the fabric slightly with one hand.
Check that there is ventilation behind the
fabric.
Check garment pockets are empty.
After ironing the main part of the laundry, you
can iron the detailed part from top to bottom as
shown in Fig. 1 to 5.
NOTE: we recommend you do not steam over
metal accessories, use caution and steam
around the metal accessories.
STEAM CURTAINS:
Wash and dry curtains as directed, according
to the fabric type.
Hang the curtains and steam when they are
hanging in place.
Lightly stretch the curtain with one hand while
steaming to help remove creases more easily.
STEAM UPHOLSTERY:
The garment steamer can be used to help
freshen up upholstery, slip covers on furniture
and cushions from the furniture and in the
room, before steaming, always test on a small
area of the fabric that is not visible.
Keeping the garment steamer in an upright
position and using and up and down motion,
lightly steam over the fabric of your furniture,
cushions should be removed and held upright
for steaming, allow cushions to dry thoroughly
before replacing on furniture.
AFTER USE OF THE APPLIANCE HAS
ENDED:
Press the power button for a few seconds, you
will see that the light on the appliance goes
out.
Unplug the appliance from the mains.
Remove the water from the tank.
Let it cool down.
Clean the appliance.
ATTACH ACCESSORIES
CAUTION: Always allow the steamer to
cool down before assembling or removing
accessories.
Assembling accessories:
Soft brush (J.a) and fur brush (J.b): Align the
upper part of the accessory to the steam head
and press the lower part until you hear a click.
The resin filter (J.c) is mounted under the
water tank:
Remove the water tank, remove the current
filter after 3 months and replace it with the new
one.
Apply light pressure to make sure that the filter
is watertight.
Replace the water tank.
AUTO OFF
If the product is not used for 8 minutes, it will
automatically switch off.
If there is insufficient water in the product, the
pump will empty for 60 seconds and then the
appliance will switch off automatically.