Genie 240 S Manual Del Usuario página 11

Delivery:
240 S Shredder
paper basket
Manual
Setting up the document shredder:
1. Place the shredder attachment on the basket. When fitting it, pay attention that the attachment
fits securely and that your fingers do not get jammed between the top edge of the waste bin and
shredder. Risk of injury!
2. Connect the main plug to a standard 220–240-volt AC socket.
Starting the document shredder:
Important note:
This device is designed solely for private use in enclosed quarters and for brief operation not
exceeding 2 minutes. Do not use the document shredder for commercial applications nor
outdoors. Improper use poses risk of accidents.
The main switch has 3 positions. To start the device set the button into position "AUTO".
1. AUTO (ready to operate, Standby): The device is ready to operate after setting the sliding switch to
"AUTO". The shredding process begins automatically when the paper to be shredded is fed into
the insertion slot.
The paper must be fed STRAIGHT into the insertion slot to prevent paper jamming.
After the paper has been shredded by the cutting mechanism, the shredder switches off
automatically and enters Standby mode. If the device does not switch off automatically, check
whether the waste bin is full or there is still residual paper in the cutting mechanism.
Only insert paper into the designated feed slots!
2. REV (reverse operation) : "REV" make the cutting unit turn backward. With these function paper
jams can be removed (please refer to chapter "Protection against paper jams and overloading").
3. OFF position is recommended when emptying the wastebasket or when the shredder is not in use
for a prolonged period.
11