Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
7
Making the water supply
connections
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
□
Use wrenches to tighten the connections. Do not
overtighten.
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is completed, turn on the
hot and cold water supplies. Check for leaks.
□
Ensure the faucet (A) handles are in the off
position, and turn on the water supply to check
for leaks. If you discover any leaks, check your
connections to ensure they are installed properly.
□
Pull the hose assembly out of the spout and
remove the aerator (1) by unscrewing it from
the hose in a counterclockwise direction. Be
sure to hold the end of the hose down into the
sink and turn on the hot and cold handles to
allow the water to run for at least one minute.
This ushes away any debris that could cause
damage to internal parts. Check for leaks.
□
Re-tighten any connections if necessary, but do
not overtighten. Reinstall the aerator by hand
tightening it back onto the hose in a clockwise
direction.
2
Switching the spray pattern
□
Rotate the aerator to switch the faucet spray
pattern.
□
The rotation angles of the aerator range from
0 to 360 degrees.
1
3
360°
7
Please contact 1-855-HD-GLACIER for further assistance.
2
A
1
HOMEDEPOT.COM/GLACIERBAY
Publicidad
