Descargar Imprimir esta página

Maintenance; General; Maintenance Schedule; General Inspection - McCulloch M40-125 Manual De Instrucciones

Ocultar thumbs Ver también para M40-125:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 114

General

WARNING! The user must only carry out
!
the maintenance and service work
described in this Operator's Manual.
More extensive work must be carried out
by a service workshop.
Prevent unintentional starting by
removing the ignition cable from the
spark plug.
The life span of the machine can be
reduced and the risk of accidents can
increase if machine maintenance is not
carried out correctly and if service and/or
repairs are not carried out professionally.
If you need further information please
contact your nearest service workshop.
CAUTION! When the machine is tilted, make sure the air
filter always is placed in the highest position.
Always use genuine accessories.

Maintenance schedule

In the maintenance schedule you can see which parts of
your machine that require maintenance, and with which
intervals it should take place. The intervals are calculated
based on daily use of the machine, and may differ
depending on the rate of usage.
Weekly
Before starting

maintenance

General inspection Spark plug
External cleaning
Muffler*
Oil level
Cutting equipment
Cutting cover and
protective cover*
Adjusting the
clutch wire
Engine brake
handle*
*See instructions in the section "Machine's safety
equipment".

General inspection

Check that nuts and screws are tight.
External cleaning
Brush leaves, grass and the like off of the lawn mower.
Do not use a high pressure washer to clean the
machine.
MAINTENANCE
Oil level
The lawn mower should stand on flat ground when you
check the oil level. Check the oil level with the dipstick on
the oil filler cap.
Cutting equipment
CAUTION! The blades should be balanced after
sharpening. Balancing, replacing or sharpening the
blades should be conducted by a service workshop.
Damaged blades should be replaced when hitting
obstacles that result in a breakdown. Let the service
Monthly
centre assess whether the blade can be sharpened or
maintenance
must be replaced.
Air filter
Replacing the blades
Replacing and
adjusting the
centre belt
Fuel system
Dismantling
Never flush water directly on the engine.
Clean the air intake on the starter. Check the starter
and starter cord.
When cleaning under the cutting hood, turn the
machine with the spark plug upwards. Empty the fuel
tank.
Remove the oil cap and wipe the dipstick clean.
Put the dipstick back in. The oil filler cap must be
completely screwed down to give a correct picture of
the oil level.
If the oil level is low, fill using engine oil up to the upper
level on the dipstick.
Check the cutting attachment for damage or cracks. A
damaged cutting attachment should always be
replaced.
Always ensure the cutter is well ground and balanced
correctly.
WARNING! Always wear heavy-duty
!
gloves when servicing and maintaining
the cutting equipment. The cutters are
very sharp and cuts can occur very
easily.
Unscrew the bolt holding the cutter.
Remove the old blade. Make sure the blade bracket is
free of damage. Also check that the cutter bolt is
undamaged and that the engine shaft is not bent.
English
11

Publicidad

loading

Este manual también es adecuado para:

M46-125M46-125rM46-125rxM46-140rM51-140rM51-140rp