Philips HF3480 Manual página 10

EnglisH
10
- Wind chimes (Fig. 15)
snoozing
Push down the control lever to the bottom position when the alarm goes off. (Fig. 16)
1
The lamp continues to be on at the selected intensity level, but the alarm sound stops. After
,
9 minutes, the wake-up sound is automatically played again.
Note: The 9-minute snooze time is fixed. This time cannot be adjusted.
Note: If you push down the control lever with too much force, it may jump back to off position.
alarm demonstration
If you want to get a quick demonstration (60 seconds) of the gradually increasing light level and
sound level, activate the test function of the appliance.
Push the control lever down to the bottom position for a few seconds until TEST appears on
1
the display (Fig. 17).
Push the control lever down again to stop the demonstration.
2
Note: The appliance continues to run the alarm demonstration until you push down the control lever
again. The test automatically stops after 9 hours.
radio/volume
1 To switch on the radio, press the bottom function selector. (Fig. 18)
To select the desired radio frequency, move the middle function selector (SET) up or
2
down (Fig. 19).
Tip: To scan radio frequencies automatically, press and hold the middle function selector (SET) for approx.
2 seconds.
Tip: To make sure you get a good radio signal, fully unwind the antenna and move it around until you
have found a position at which reception is best.
3 To switch off the radio, press the bottom function selector again.
volume
To set the volume, move the bottom function selector up or down to select the volume level
1
you prefer.
You can choose a volume level between 1 and 20.
Note: The volume level you have selected is automatically set as the volume level for the alarm as well.
Dusk function
You can use the dusk function when you want the light and/or the sound of the Wake-up Light to
stay on and dim gradually during a set period of time (15 minutes to 2 hours) before you go to
sleep. The lamp and/or sound switch off automatically after the set time.
Follow the steps in section 'Menu functions of middle function selector (SET)' in this chapter
1
to select the dusk function and to set the dusk function time.
Note: You can choose a time from 15 to 120 minutes (15, 30, 60, 90 or 120 minutes).
, After the set time, no matter whether only the light and/or the radio are on, the dusk
function switches off both light and sound.
cleaning and maintenance
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.