Publicidad
Idiomas disponibles
Idiomas disponibles
ATTACHMENT HOLDER
Align the attachment holder clip with the
front of wand. Push and snap into place on
wand.
HOSE
To install: Line up the hose latch tab with
the notch in the canister hood, and insert
hose into canister until it snaps into place.
ASSEMBLY INSTRUCTIONS
- 10 -
IMPORTANT:
Push hose firmly into the canister until
the hose latch tab snaps into place. The
vacuum cleaner will not operate until hose
is fully connected.
To remove: Do not open hood before
removing hose. With hood closed, press
the hose latch tab in to release and remove
hose.
CANISTER
1. Open the canister hood.
2. Check to see that the dust bag
is properly installed. See DUST
BAG CHANGING (page 18-19) for
instructions.
3. Check to see that the motor safety
filter is properly installed. See MOTOR
SAFETY FILTER CLEANING (page 19) for
instructions.
Publicidad
