HTW NEO -BP21MDA Manual De Usuario E Instalacion página 34

USER AND INSTALLATION MANUAL
5. INSTALLATION
During the first months of use, your heat pump is subject to condensation. This will result in water flows,
more or less important depending on the moisture content, which will gradually diminish.
To channel condensation flows, we recommend that you install our condensate drain kit.
For this purpose the heat pump must be raised by at least 10 cm.
How to install the condensate drain kit?
1. Install your heat pump by raising it by at least 10 cm using solid, moisture-resistant studs.
2. Connect the exhaust hose to the drain hole located underneath the heat pump.
It is a kit usually consisting of:
• 3 valves
• 2 T
We recommend that you only half
open your intermediate valve to avoid
excessive pressure on your heat pump
(see diagram).
if your setting is correct, the pressure
gauge of your heat pump will be in
working order.
5.7 SINGLE INSTALLATION MANUAL
WATER OUT
WATER IN
32

A "By-Pass Ø50" kit is essential for the
installation of your heat pump.
• 2 elbows of diameter 50mm
• 1 stripper and 1 glue.
CIRCULATION PUMP
VENT
SWIMMING POOL HEAT PUMP/ SPA NEO
OUT
WATER OUT
IN
WATER IN
POOL
FILTER
Open Full Valve
Open Half Valve