Jimmy BX7 Manual Del Usuario página 7

Brushroll blockage indicator
When the brushroll is blocked,the machine will stop
and the indicator turns red.(Figure 4)
Note:
1.When the dust over the Max line,please clean the dust cup
and MIF filter in time.
2.For safety reasons, the UV light only works within 3cm above
object as well as less than 30 inclination degrees. Otherwise,
the UV light will automatically turn off.
3.Do not touch the air outlet on the bottom of the machine in
case of hand scald.
Cleaning and maintenance
Note:
1.MIF Filters is available for sale at JIMMY distributor.
2.It is recommended to clean the dust cup after each use.
when the filter is blocked due to excessive dust accumulation,
it needs to be cleaned and replaced if necessary.
Dust cup and filter cleaning
1.Turn off the machine and unplug the power cord. Then
press the release button and lift upward.(Figure 5)
2.Hold dust cup lid and rotate to remove cyclone
assembly from dust cup for cleaning.（Figure 6）
3.Remove the MIF filter along the direction shown in
the figure for better cleaning.（Figure 6）
Note:
1.Do Not miss the filter!
2.Use water or neutral reagents to clean dust cup and wipe
with dry cloths. Do not wash the filter until it is necessary. Make
sure the filter and dust cup are completely dry before another
use.
Brushroll cleaning and installation
Turn off the machine and unplug the power cord, slide
the brushroll cover latch with hand from locked position
to unlock position to remove the brushroll to clean up
with the mini- brush(Figure 7).After brushroll cleaning,
install the brushroll and the brushroll cover into the machine in turn.
If the backward brushroll is hard to clean after being entangled by hair, thread and other
filaments, take out the backward brushroll and use a blade to cut the hair, thread and other
filaments along the backward brushroll for cleaning. (Figure 8)
4
5
Handle
6
Cyclone
7
Unlock
Lock
8
Mini Brush
Backward brushroll
Dust cup
release button
MIF filter
5