Publicidad
Idiomas disponibles
Idiomas disponibles
FAN OPERATION
WARNING:
Before assembling the fan, make sure all parts are present. Compare parts with
contents list. If any part is missing or damaged, do not attempt to assemble, install, or operate
the product. Contact customer service for replacement parts. Unplug fan before assembling
any parts to it.
1. Tools Required (Not Included):
#2 Phillips Screwdriver or Suitable Drill Equipped with #2 Phillips Bit.
2. Fan Cradle Assembly:
Simple assembly is required before using this fan.
• Place the adjustment knob pad (G) on the left and right sides of the drum (B).
• Align and insert the adjustment knob (D) to the tripod (E) and adjustment knob pad (G) ,
tighten them with the drum (B).
Always operate the fan with the cradle in its upright position. The fan itself can
Fan Operation:
be titled into various positions depending on applications, including straight upward.
Place the fan in an area in the room that will provide the most effective air circulation.
Fan Location:
Plug fan directly into 120 volt A.C., 60Hz wall outlet. Be sure plug fits tightly in outlet.
Fan Connection:
A loose connection may cause overheating and damage to the plug or fan.
NOTE:
To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other
electrical loads.
Turning Fan On:
Place fan on stable level surface. Plug fan into properly grounded outlet. To start
the fan, turn the switch from the OFF position to the desired fan speed.
To turn the fan off, turn the switch from the current fan speed setting to the
Turning Fan Off:
off position. Remove plug from outlet.
Adjusting Fan Tilt:
Adjust the fan to desired tilt angle and re-tighten the knob. Do not overtighten adjustment knob.
CARE and MAINTENANCE
CLEANING:
WARNING:
Before cleaning the fan be sure to disconnect power cord from the plug.
Clean the grille surface with a clean damp cloth. Do not use harsh chemical or abrasive cleaners.
DO NOT IMMERSE THE FAN OR ANY WIRES IN WATER.
WARNING:
Replace front grille before fan use and allow fan to dry completely before use. Periodic grille cleaning
with a vacuum will prevent dust build up. The motor is sealed and does not require any interior
maintenance, cleaning or lubrication.
MAINTENANCE:
The Internal motor bearings are permanently lubricated at the factory and do not require
any additional lubrication.
Loosen the adjustment knob until the drum rotates freely on the frame.
6
ENGLISH
B
G
E
D
Publicidad
