Publicidad
Idiomas disponibles
Idiomas disponibles
Fax +32 030 9904733
#
• To not place the appliance near sinks or other container of liquids (minimum distance of 2 meters) to
avoid the risk of it falling in.
• The power socket must be easy to reach so the plug can be removed quickly in case of emergency.
• Ensure that the cable is positioned correctly and that it is not touching hot parts, sharp edges, wound
around the appliance, twisted on itself.
• Keep the fan far away from fabrics (curtains, etc.) or unstable materials that could obstruct the air
intake grille; make sure that the front is free of unstable materials (dust, etc.).
• Do not place the appliance near an open flame, cooking or other heating appliance.
• Make sure that the electric cord is not touching rough, hot or moving surfaces and not twisted or
wrapped around the appliance.
• Stand the appliance on a horizontal, flat surface or table; do not stand on a inclined plane (the appliance
could upset).
• Do not use the appliance with a timer or a programmer or with a system that can switch on the
appliance automatically, to avoid risk of fire, since a fire risk exists if the heater is covered or
positioned incorrectly.
• In the event of a breakdown or poor operation, turn the fan heater off and ask for professionally
qualified help; repairs made by unqualified persons can be dangerous and render void the warranty.
Wall installation
If the appliance is fitted to a wall, the same must be made of masonry and/ or of heat-resistant material
(not of wood or synthetic material); follow the indications below for installation:
- fit using the two "lock hole slots" in the support: make two holes in wall 24 cm. apart, perfectly
horizontal; insert expansion wall anchors into the same and screws suitable for the slots
Portable installation
Please put the appliance on a secure surface, verify that the area around the surface is clean, without dust.
USE
Before each use, verify that the unit is in good condition, the electric cord is not damaged, if the power
cord is damaged, it must be replaced by the manufacturer or a competent qualified electrician or a person
with similar qualifications, in order to avoid any risk.
Please insert the plug into the socket and select the speed desired turning the knob. It is positioned on
•
the back side: position "0" off, position "1" minimum speed, position" 2" medium speed, position
"3" maximum speed.
The fan can be manually adjusted up and down by the air grating and according to his inclination (
•
about 180°).
To switch off the appliance, turn the knob in "0" position and pull out the plug from the socket.
•
When not in use for long periods, the plug must always be removed from the socket
CLEANING AND MAINTENANCE
Attention: before normal cleaning, remove the plug from the socket.
• Clean the body with soft, slightly damp, cloth; do not use abrasive or corrosive products.
• Do not immerse any part of the fan in water or other liquid: if this should happen, do not put your hand
in the liquid, but first remove the plug from the socket. Carefully dry the appliance and make sure that
all the electrical parts are dry: in the case of doubt, ask for professionally qualified help.
• It is essential that the motor's air holes be kept from dust and lint.
• Periodically check the electric cord for damage; its replacement requires a special tool: contact an
authorized service center, also for any repairs.
• If the fan will not be used for long periods, it must be protected from dust and humidity; we
recommend storing it in its original packaging.
• Should you decide not to use the appliance any more, we recommend making it inoperative by cutting
the power cord (after making sure you have disconnected the plug from the socket) and make
dangerous parts harmless if children are allowed to play with them (such as the blade).
• Do not dispose of non-biodegradable products in the environment but dispose of them in accordance
with current law. At the end of its working life, the product must not be disposed of as urban waste. It
Copies of the I/B. Please reproduce them without any
changes except under special instruction from Bimar (Italy).
The pages must be reproduced and folded in order to obtain
a booklet A5 (+/- 148.5 mm width x 210 mm height). When
folding, make sure you keep the good numbering when you
turn the pages of the I/B. Don't change the page numbering.
Keep the language integrity.
6
16
/
Assembly page 6/16
Publicidad
