Power Dynamics PDWS3 Manual De Instrucciones página 4

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging. If the device has been exposed to
drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The arising condensation water might
damage your device. Leave the device switched off until it has reached room temperature.
MOUNTING THE VOLUME CONTROL
The volume control is designed to be mounted in a DIN 49073 electrical wall box, with a
depth of at least 50mm (the package includes a universal wall mount box too).
Select a location that is within reach of the speaker wires and easy to
reach when wanting to operate the volume control. Measure accurately before initiating the
cutting/sawing/drilling process!
Warning: Do not mount the volume control directly on a wall!
CONNECTIONS
1. Connect the speaker cable to the speaker control:
A. Strip 6mm of insulation from the end of each cable.
B. Tightly twist the wires in each cable until there are no frayed ends.
C. Insert the 6 speaker cables from the amplifier into the input area.
D. Insert the 6 speaker cables (as you can see below in the picture)
2. If you don't use any Volume control unit next to this unit, you need to connect the cables as on the right side on the picture.
3. Screw box into place, put the ABS faceplate on.
4