Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 29
Fig. 30
CLEANING THE TURBO BRUSH (model
NV350WM)
1
Slide the locking latch (a) forward and tilt the
bottom cover upward to remove. (Fig. 29)
2
Carefully remove any blockage or debris and
cut away any build-up of hair or string wrapped
around the rotating bristle brush with scissors.
3
To reassemble, insert the tabs on the front edge
of the bottom cover into the matching holes in the
top half and tilt it back down until it clicks into
place. (Fig. 30)
CLEANING THE MOTORIZED FLOOR BRUSH
When your motorized floor brush needs cleaning or
locks onto an object, it automatically shuts down to
prevent damage to your lifetime belt. The indicator
light will illuminate red warning you to turn off the
vacuum and clear blockage immediately. The light will
reset itself once blockage has been cleared and power
has been cycled on/off or vacuum has been locked in
the upright position.
1
Detach the motorized floor brush from the
detachable canister.
2
Inspect the opening underneath and the rotating
brush. If a build-up of debris is present, remove it.
Carefully cut anything wound around the rotating
brush with scissors. Avoid damaging or cutting
the bristles. (Fig. 31)
NV350_26_NV350A_26_NV350E_26_NV350T_26_NV350WM_26_IM_ENG_SPA_100929.indd 15
a
Rotating
Brush
Fig. 31
CHECKING FOR BLOCKAGES
Blockages may cause your vacuum to overheat and
shut down. To prevent this from happening, check
potential blockage areas after heavy use or if you
detect a loss of suction or poor cleaning performance.
1
2
3
4
Make sure you are working in a well
lit area and use a flashlight to help
search for blockages.
Dust Cup
Dust cup may be full. Empty dust cup.
Pre-Motor & Post-Motor Filters
Pre-motor filters require washing every 3 months
for optimum performance. The post-motor filters
needs to be washed every 12 months.
Ensure that all the filters are clean.
Accessories
• Check intake openings:
- Extension Wand
- Dusting Brush
- Crevice Tool
- Turbo Brush
- 24" Crevice Tool
Hose and Connections to Vacuum
• Detach the stretch hose from the back of the
detachable canister by squeezing the tabs
together and pulling up. (Fig. 32) Straighten
out the hose and look inside for blockages.
www.sharkclean.com
English
Fig. 32
15
10-09-29 11:47 AM
Publicidad
