Publicidad
Section 3 - mydlink
1
Device Name
2
Privacy Mode
3
Motion Settings
4
Point to Go
5
Auto Home
6
Storage
7
Camera Microphone
8
Night Vision
9
Anti-Flicker
10
Invert Image
11
Pan-Tilt Control
12
Status LED
13
Designated Contact
14
Wi-Fi
15
Time Zone
16
Firmware
17
MAC ID
18
Remove Device
D-Link DCS-6500LH User Manual
Tap to change the device's name.
Tap to enable. Privacy mode will disable the camera feed.
Tap to further configure sensitivity and the active area of motion
detection.
This photo is what you will see when you control your viewpoint in the
camera's Point to Go live-view. Tap Rescan to scan a new panorama.
Enable to automatically return your camera to the set 'Home Point'
after 60 seconds of inactivity.
Tap to change the video clips storage location from the microSD card to the
cloud. You can also subscribe to mydlink Cloud from here and view your
current subscription plan.
Tap to enable or disable picking up sound near your camera in live view
and recordings.
Tap to change night vision detection to On, Off or Auto.
Reduces flicker in the video. Tap 50 Hz or 60 Hz depending on the frequency
of your lights.
Enable this to invert the camera view.
Choose whether to control your camera's Point to Go live-view pan-tilt
control by Swiping or Tapping
Disabling this will turn off the LED until you turn it back on.
Tap here to add, remove, or edit designated contacts that appear in the
rich notification.
Tap to see the current wireless network. Note: Tap Remove Device
or press the reset button if you want to change wireless networks.
Select the time zone to calibrate your device to.
This displays the installed version of the firmware on your device. Tap to enter
the update settings. You can choose the most suitable time for automatic
updates.
Identifies the device for support issues.
Tap this button to disconnect this device from your mydlink account.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
13
Publicidad
