Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning the exhaust filter:
1.
To remove the exhaust filter, open the bag door and remove the filter pack. [19]
Wash the filter in hand warm water [16] and allow it to dry [17] thoroughly before
2.
replacing to the cleaner. [20]
REMEMBER: Do not use hot water or detergents. In the unlikely event of the
filters becoming damaged, fit a Genuine Hoover replacement. Do not try and
use the product without a dust bag or filter fitted.
Cleaning the permanent cloth dust bag* (certain models only)
To maintain optimum performance we recommend that you wash the permanent cloth
dust bag under hand warm water after every 5 full bags. Remove excess water and leave
to dry fully before replacing.
Removing a blockage from the system
If the bag check indicator is red:
1.
Check if the bag is full. If so refer to 'Replacing The Dust Bag'.
2.
If it is not full, then;
A. Do the filters need cleaning? If so refer to 'Cleaning the Filter'.
B. Check if there is any other blockage in the system - Use a rod or a pole to
remove any blockage from telescopic tube or flexible hose.
WARNING*: - The bag check indicator will remain red if the cleaner is used when the bag is
full, if there is a blockage or if the filters are dirty. If used for a period over ten minutes with
the bag check indicator red,an electronic cut out will switch the cleaner off to prevent any risk
of overheating. If this should happen,switch the cleaner off,unplug and correct the fault(see
'Removing a blockage'). The cut out will automatically reset upon switching the cleaner back on.
ACCESSORIES AND NOZZLES
To obtain the best performance and energy efficiency
correct nozzles are used for the main cleaning operations. These nozzles are indicated
in the diagrams by the letters GP, HF or CA.
A nozzle type GP can be used to clean both carpet and hard floor.
A nozzle type HF is suitable for use only on hard floor.
A nozzle of type CA is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
It is important to note that this vacuum cleaner is supplied with an Energy Label as re-
quired by European Regulation (EU) 665/2013.
If the label shows a red prohibition circle on the left covering the carpet symbol, then this
indicates that the vacuum cleaner is not suitable use on carpets.
If the label shows a red prohibition circle on the right covering the hard floor symbol, then
this indicates that the vacuum cleaneris not suitable for use on hard floors.
#1
NOTE: Dust pick up ability carpet, dust pick up ability hard floor, and energy efficiency
#1
it is recommended that the
3
in accord with Commission Regulations (EU) 665/2013 and (EU) 666/2013.
The crevice tool*, furniture nozzle* and dusting brush* are stored on board under the
accessories door. And they can be fitted to the handle or the end of telescopic tube. [21]
•
Crevice Tool* – For corners and hard to reach areas. [V1]
• Dusting Brush* – For bookshelves, frames, keyboards and other delicate areas. [V2]
•
Furniture Nozzle* – For soft furnishings and fabrics. [V3]
•
Parquet Nozzle* – For parquet floors and other delicate floors. [Z1, Z2]
•
Pet Hair Remover Mini Turbo Nozzle*– Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. [W]
•
Allergen Remover Mini Turbo Nozzle* – Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. [X]
•
Grand Turbo Nozzle* – Use the turbo nozzle for deep cleaning on carpets. [Y]
IMPORTANT: Do not use the grand turbo nozzle or mini turbo nozzles on rugs with long
fringes, animal hides and carpet pile deeper than 15mm. Do not keep the nozzle stationary
while the brush is rotating.
USER CHECK LIST
Should you have a problem with the product, complete this simple user checklist before
calling your local HOOVER service.
•
Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
•
Is the dust bag over-filled? Please refer to 'Cleaner Maintenance'.
•
Is the filter blocked? Please refer to 'Cleaner Maintenance'.
•
Is the hose or nozzle blocked? Please refer to 'Removing a blockage from the system'.
•
Has the cleaner overheated? If so, it will take approximately 45 minutes for the cut
out to automatically reset.
•
IMPORTANT INFORMATION
HOOVER spares and Consumables
Always replace parts with genuine HOOVER spares. These are available from your local
HOOVER dealer or direct from Hoover. When ordering parts always quote your model number.
Consumables
•
Paper Bag:
•
HEPA Bag:
•
Filter kit (pre-motor and exhaust):
Spares
•
Carpet and Floor Nozzle:
•
Hard Floor Nozzle:
•
Carpet Nozzle:
•
Parquet Caresse Nozzle:
•
Pet Mini Turbo Nozzle:
*Certain Models Only
** Certain models only, nozzles may vary according to model
H72, 35601374
H73, 35601375
U68, 35601376
G201EE, 35601594
G208EE 35601601
G211EE 35601604
G89PC, 35600659
J51, 35601163
GB
Publicidad
