Publicidad
Idiomas disponibles
Idiomas disponibles
EN Application sheet
In the recirculation mode (see Fig. 8), the kitchen
hood is not connected to the air shaft, and thus the
air is just passed through the kitchen hood inside
the kitchen.
In this mode, charcoal acrylic disposable scent-
trap filters should be installed on the kitchen hood.
These filters are not included in the set and are
bought separately. The use of the kitchen hood in
the recirculation mode reduces its productivity.
We recommend using the kitchen hood in the
mode of air extraction to the air shaft.
MAINTENANCE AND SERVICE
OF THE KITCHEN HOOD
Disconnect the power supply before you
start any operation related to cleaning or re-
pair of the kitchen hood.
Use the cloth damped in warm water with a neutral
detergent for external cleaning of painted kitchen
hoods. Use special detergents and follow the rele-
vant instructions for external cleaning of steel, cop-
per and brass surfaces. Never use the detergents
that contain acids or chloride, abrasive products or
sponges that may scratch the surface.
The aluminum grease trap filter becomes polluted
as it traps the particles of fat coming through it. It
should be cleaned with products that do not con-
tain acids or washed after preliminary soaking in
hot water using an efficient detergent or, if possible,
in the dish-washer (at a temperature of 65°C). Ex-
tremely polluted grease trap filters should not be
washed in the dish-washer along with kitchenware.
Aluminum filters should be cleaned once in 1.5-2
months, which will be reminded by a relevant signal
on the display of the kitchen hood remote control
(see the remote control description in the para-
graph "Kitchen hood control").
Simultaneously with cleaning of the grease trap fil-
ter, clean all the accessible elements of the kitchen
hood case from grease deposits.
KITCHEN HOODS
To disconnect the aluminum filter (Fig. 9), press the
spring lock on the filter and pull it and then press
down to remove. When you remove the filter, do not
apply the effort to the aluminum surface of the filter
as it may lead to dents on its surface, affecting the
external appearance of the filter.
Do not install the filter in the kitchen hood until it
is completely dry.
The filter is installed in the reverse order. Press the
spring lock on the filter and put it in place, after
which release the lock.
Coal filters, if they are installed and the hood works
in recirculation mode, should be changed once ev-
ery 5 months. For your hood, two coal filters are
installed. They are installed on aluminum grease fil-
ters. To remove the coal filter, it should be carefully
removed from the pressure plates mounted on the
aluminum grease filter
The hood has are minion type illumination lamps. To
change the light bulb, remove the aluminum grease
filters and remove the burned lamp from the socket
(Fig. 10). Instead, it is necessary to screw in the lamp
with the same characteristics and install filters. Re-
placing lamps and filters is not included in the war-
ranty service.
Attention!
Lamps are heated strongly, in order to avoid
burns, replace the lamps only when the hood is
off.
Attention!
The hood backlight lamps serve to illuminate
the hob during cooking and are not designed for
long-term operation as a kitchen lighting. Pro-
longed use of backlight can lead to premature
failure of both lamps and the hood itself.
The removal and replacement of the lamps and
filters is not included in the warranty service.
Replacement of coal filters
Replacing the backlight lamps
9
Publicidad
