EVVO 4 Manual De Instrucciones página 33

ENGLISH
When switched on, the appliance will operate in low-power mode by default, and the
display will show the temperature.
Note
If you switch off the appliance, you will lose the temperature and timer settings
selected.
Modes
Standby mode
Press the Mode button to select Standby mode. The icon shown in Figure 15 will light
up. This function allows you to keep the appliance switched on and maintain the
timer setting without it emitting heat.
Heating mode
Press the Mode button to select Heating mode. The icon shown in Figure 16 will
appear on the screen.
Temperature
- Press the temperature button to select the desired temperature. The temperature
can be set from 5 oC to 40 oC.
- Each time the appliance is switched on, the display will show the internal temperature
of the appliance.
- You can set or stablish the temperature in the standby mode or while it is operating.
- When the room temperature reaches the set temperature, the device will stop
operating at high power.
- When room temperature is 2°C above the set temperature, the appliance will stop
emitting heat. The appliance will only resume heat emission when room temperature
is 2°C below the set temperature.
Timer
- Use the Timer button to select the time you want to switch the appliance on or off
at, in a range of 1 to 24 hours.
- To deactivate this function, press the Timer button repeatedly until the display
33
EMISOR TÉRMICO C4/C6/C8/C10/C12 BLANCO