Publicidad
TO ADJUST BAGGER ASSEMBLY
HORIZONTAL ADJUSTMENT
The tractor comes from the factory with the bagger assembly preset
in a fixed position. If necessary, this position can be adjusted to
maintain a consistent gap (A) between the fender and the bag-
ger assembly top. An ideal gap is approximately 0.25" (6 mm).
•
Insert 1/2" (13mm) wrench under bagger assembly top (1).
Do NOT remove; ONLY loosen adjustment bolt (2). Repeat
on opposite side.
•
Slide bagger assembly into proper position.
2
•
Once bagger assembly is in proper position, tighten adjust-
ment bolts (2) on both sides to 100 In-Lbs/11,2 Nm. Do NOT
overtighten.
•
Readjust if necessary.
VERTICAL ADJUSTMENT
If necessary, the vertical position of the bagger assembly can be
adjusted to maintain proper alignment (B) between the fender
and the bagger assembly top.
•
Remove bagger assembly.
•
Do NOT remove nuts (3); ONLY loosen nuts (3).
NOTE: The bagger height indication marks (4) can be used to
help determine how much the bagger supports (5) will need to
be moved.
•
Raise or lower bagger supports (5) to proper position and
retighten nuts (3).
4
5
•
Replace bagger assembly onto bagger supports (5).
•
Readjust if necessary.
1
1
4
3
ELECTRIC BAGGER ASSEMBLY ADJUSTMENT
Following bagger adjustment, it may be necessary to adjust the
electric bagger assembly.
•
Remove bagger assembly.
•
Loosen bolt (1) on each side of the lower clevis bracket (2).
•
Move the bracket up or down as needed until alignment
holes (3) are properly lined up and retighten bolts (1).
•
Reinstall the bagger assembly.
3
•
Using the switch, fully open the bagger assembly. (See "TO
OPERATE ELECTRIC DUMP SYSTEM" in section 5 of this
manual.)
•
Lower the bagger assembly and ensure that the bagger as-
sembly closes securely onto the bagger spring latches. (See
"BAGGER SPRING LATCH ADJUSTMENT" in this section
of the manual.)
NOTE: If the bagger assembly does not close securely with the
bagger spring latch, further adjustment may be needed. Repeat
adjustent procedures until bagger assembly is properly secured
to bagger spring latch.
5
23
1
2
2
Publicidad
