Philips S93 Serie Manual De Instrucciones página 22

18
English
3 Place the shaver in the holder (1), tilt the shaver backwards (2) and
press down the top cap to connect the shaver ('click') (3) (Fig. 18).
The battery symbol starts to flash, which indicates that the shaver
is charging.
4 Press the on/off button on the SmartClean system to start the
cleaning program (Fig. 40).
During the rinsing phase, the rinsing symbol flashes (Fig. 40). When
the rinsing phase is done (after approx. 10 minutes), the rinsing
symbol lights up continuously.
After the rinsing phase, the drying phase starts automatically. During
this phase, the drying symbol flashes (Fig. 41). When the drying phase
is done (after approx. 4 hours), the drying symbol lights up
continuously.
When the cleaning program is done, the ready symbol lights up
continuously (Fig. 42).
30 minutes after the cleaning program and charging are done, the
SmartClean system switches off automatically.
The battery symbol lights up continuously to indicate that the shaver
is fully charged (Fig. 42). Charging takes approx. 1 hour.
Note: If you press the on/off button of the SmartClean system during
the cleaning program, the program aborts. In this case, the rinsing or
drying symbol goes out.
Note: If you remove the supply unit from the wall socket during the
cleaning program, the program aborts.
Replacing the cartridge of the SmartClean system
Replace the cleaning cartridge when the replacement symbol flashes
orange or when you are no longer satisfied with the cleaning result. If
you clean the shaver in the SmartClean system once a week, the
SmartClean cartridge lasts approximately three months.
1 Press the button on the side of the SmartClean system (1) and lift
the top part of the SmartClean system (2).
2 Remove the cleaning cartridge from the SmartClean system and
pour out any remaining cleaning fluid (Fig. 43).