Pur Line CHE-500 Manual De Usuario página 16

2. When working time reached set time, the unit would be automatically turned off and on standby.
3.When there is conflict on this set time and the Cut-off time under "Weekly Setting" mode, the unit would be
turned off as per the time whichever occurs earlier.
* Press and hold this button 2seconds to enter Time Calibration mode.
1. The control board would display "00:00", and user could start to correct time by pressing button TEMP and
TIMING
2. Then press HEAT to confirm the time correction, and move to date correction. "d1" would be displayed.
3. Correct date by pressing button TEMP and TIMING , and press HEAT to confirm and complete the Calibration.
Note: 1. Indicator "O" would be on during time calibration.
2. "d1"=Monday, "d2"=Tuesday........."d7"=Sunday
F. Set up(Weekly Setting)
* Press this button to enter Weekly Setting mode, and indicator DATE on.
1. Firstly select the date by pressing TEMP and TIMING button from "d1" to "ALL". Press HEAT to confirm your
selected date; and enter Start-up Setting mode on selected date, indicator DATE on.
2. Press TEMP and TIMING to set Start-up Time(Hour). Press HEAT to confirm and move to Start-up Time(Minutes)
setting.
Press TEMP and TIMING to set Start-up Time(Minutes). Press HEAT to confirm and move to Cut-off Time(Hour)
setting, and indicator OFF on.
3. Press TEMP and TIMING to set Cut-off Time(Hour). Press HEAT to confirm and move to Cut-off Time(Minutes)
setting.
Press TEMP and TIMING to set Cut-off Time(Minutes). Press HEAT to confirm and move to Room Temperature
setting, and indicator ºC or ºF on.
4. Press TEMP and TIMING to set Room Temperature. Press HEAT to confirm, and complete setting on the
selected date.
Note:
1. User can set Room Temperature and Start-up/Cut-off Time of every day.
2. User can make setting on other days by repeating the procedure above.
3. If "ALL" selected, it means that the fireplace would conduct the same setting everyday.
4. "d1"=Monday, "d2"=Tuesday........."d7"=Sunday, "ALL"=Whole week selected.
5. When heater is on, then "Start-up" Time setting is invalid, while "Cut-off" Time setting is valid.
6.When there is conflict on "Timered Time" and the Cut-off time under "Weekly Setting" mode, the unit would
be turned off as per the time whichever occurs earlier.
7. When the Adaptive Start temperature is setted lower than that temperature setted under "Weekly Setting"
mode and/or detected room temperature, the heater would not be turned on.
* When there was any setting made, indicator DATE would be on, or the indicator would be off.
* Press and hold this button SET UP 3s, all settings would be cleaned and initialized.
REMOTE CONTROL
For remote to function make sure the heater is plugger-in and mains power switch located on the right hand
side of the heater body is at position I.
Remote control has all the same buttons as on the control panel.
The remote receiver is located on the centre of the glass panel, point the remote control to the centre of the
panel and then press the desired button.
Note: 2 AAA batteries required for remote control. BATTERIES NOT INCLUDED. If the batteries are not fully charged
the remote device may not operate and the range of the device will be reduced.
EN
16